How do I redistribute EIGRP to RIP?
Analyze R3’s routing table and verify that the newly created loopback interfaces are being learned by R3. Configure R3 to redistribute EIGRP routes into RIP using a hop count of 3 then redistribute RIP routes into EIGRP using a T1 bandwidth and 20,000 microsecond delay.
How do I configure EIGRP and RIP on the same network?
- Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname R2.
- R2(config)#router rip. R2(config-router)#version 2. R2(config-router)#network 20.0.0.0.
- R2(config)#router eigrp 1. R2(config-router)#network 20.0.0.0.
- R2(config)#interface se0/0/1. R2(config-if)#ip address 30.0.0.1 255.0.0.0.
What is redistribute EIGRP?
EIGRP Redistribution is a process which allows exchanging routing information between different routing processes or from static information to routing process. Redistribution is configured on border routers which have more than one routing process enabled.
How do I redistribute EIGRP to static?
When a static route to a destination is available pointing to an interface, rather than a next hop address, it can be redistributed into EIGRP either by issuing the redistribute static command or configuring a network command for the network in the static route.
What is redistribute connected?
The redistribute connected means that along with other routes already present in EIGRP, all directly connected networks will be also advertised.
What does the redistribute command do?
The redistribute command identifies the routing source from which routes are taken, and the router command identifies the routing process into which the routes are advertised.
Which two routing protocols can be redistributed into OSPF by Cisco?
Explanation: IP EIGRP, RIPv2. These can be redistributed into OSPF by a Cisco router.
What is redistribute static in RIP?
Solution. The redistribute static command tells RIP to advertise static routes, as well as directly connected routes and the routes that have been learned from other RIP routers: Router1# configure terminal Enter configuration commands, one per line.
What is default metric of redistributed routes in OSPF and EIGRP?
Next, OSPF was configured to place any interfaces in the network of 172.16. 0.0/16 into area 0. Then, OSPF will redistribute all eigrp routes from AS 15. Finally, a default-metric of 30 was applied to all redistributed routes.
What is Cisco redistribute?
The Cisco IOS can redistribute or inject routes from one routing protocol or process into another. For example: RIP routes can be injected into an OSPF process with a RIP hop count metric converted to an OSPF cost metric. The RIP route then becomes an OSPF route to all other OSPF routers in routing domain.