How do I reset my Cisco IP Phone 7941?

How do I reset my Cisco IP Phone 7941?

Cisco 7941 / 7961 phone Factory Reset:

1. Unplug the power cable from the phone, and then plug in the cable again: the phone begins its power up cycle.
2. Immediately press and hold # until the Headset/Mute and Speaker buttons flash in sequence: release #

Why does my Cisco phone say Unprovisioned?

The unprovisioned message on the phone indicates it has not loaded a valid configuration file. The most common cause of unprovisioned I have experienced is a syntax error in the configuration file. You can http into the phone IP address and check its latest log.

How do I unlock my Cisco IP Phone 7941?

Unlock configuration:

1. Press the “settings” button.
2. Use the “navigation” button and navigate down to “Unlock Config”.
3. Press the “Select” button.
4. Enter password (Default factory password is “cisco”).
5. Press the “Accept” button to unlock configuration.

How do I reset my password on my Cisco 7941?

How to Reset the Password on a 7941 Series Cisco IP Phone

1. Hold down the “#” button.
2. Release the “#” only when the Headset, Mute and Speaker buttons have all flashed.
3. Wait while the phone resets.
4. Enter the factory default password.
5. Enter a new password when prompted.

How do I setup my Cisco IP Phone 7941?

1. Supported Models: Cisco 7940, 7941, 7960, 7961.
2. Step 1: Download Firmware & Copy to Provisioning Directory.
3. Step 2: Configure TFTP Server.
4. Step 3: Configure the phone in 3CX.
5. Step 4: Set the provisioning link using DHCP Option 66.
6. Limitations.
7. See Also.

How do you reset a Cisco router?

1. Prepare the router. Make sure the Cisco router is turned off and the power cord is plugged into both the router and the power source.
2. Locate the reset button. Look for the small factory reset button on the back of the router.
3. Use the reset button.
4. Wait for the reset to complete.

How do I reset my IP 7940?

Performing the Factory Reset on Cisco 7940, 7960 IP Phones

1. Unplug the power cable from the ip phone and then plug it back in.
2. Immediately press and hold # and when the Headset, Mute and Speaker buttons begin to flash in sequence, release the # button.