Where should electrical panels be located?
An electrical panel must be installed at least 4 feet off the ground, but cannot be higher than 6 feet. You need to also allow for the panel door to open at least 90 degrees.
How much space do you need around an electrical panel?
3 feet
The space around electrical equipment should always be clear to be on the safe side. There should be at least 3 feet of space in front of equipment with a 30 inch width as well as 612 feet of headroom space.
Is there a minimum height for an electrical panel?
General Requirements for Panel Installation This space must be at least 6.5 feet high and three square feet away from the wall, and must have a 30-inch width. This allows for safe, simple service when needed. Height: The handle of the highest grip cannot be higher than six feet, seven inches off the floor.
Can an electrical panel be located in a garage?
A breaker box in a detached garage is usually a sub-panel to the main circuit panel in the home. The advantage of installing a breaker panel in the garage is that it allows you to have multiple circuits available while only needing to run one line to the garage from the house.
How close can an electrical panel be to a corner?
For example, California’s state building code requires a minimum clearance of 30 inches horizontally in front of an electrical panel. This means you cannot place an electrical panel close to a corner if another wall, fixture or piece of furniture is within 30 inches of it.
Does an electrical panel have to be on an outside wall?
3 Answers. They are almost always on an exterior wall. In some areas they are on the outside of the exterior wall – outside your house. Most inspectors would tell you that a garage (interior or exterior wall) or in the basement exterior (right where the line comes in) are the two best locations.
What is the minimum width of the working space required at an electrical panel that is 24 wide?
610mm
wide that contains over current devices, switching devices, or control devices, there shall be one entrance to an egress from the required working space not less than 610mm (24 in.) wide and 2.0m (6½ ft.) high at each end of the working space.
Can main breaker be at bottom of panel?
Just about all modern electric panels can be mounted upside down, meaning that the main breaker is located at the bottom instead of the top. The “up” position of a vertically operated breaker switch handle must be “ON.” (NEC 240.81) The highest breaker in the panel cannot be more than 6′-7” above the floor.