Which is better RG59 or RG6?
RG6 cable is heavier gauge and has insulation and shielding tuned for high-bandwidth, high-frequency applications such as Internet, Cable TV, and Satellite TV signals. RG59 cable is thinner and is recommended in low bandwidth and lower frequency applications such as analog video and CCTV installations.
What is RG59 cable used for?
RG-59 is often used at baseband video frequencies, such as composite video. It may also be used for broadcast frequencies, but its high-frequency losses are too high to allow its use over long distances; in these applications, RG-6 or RG-11 is used instead.
Are RG59 and RG6 connectors the same?
The main difference between RG6 and RG59 is that the RG6 cables have a thicker copper wire allowing better transmission of the signal. RG6 is primarily being used today for satellite and digital cable TV, where higher frequencies are required that RG59 cable cannot support.
How do I know if my cable is RG6 or RG59?
RG-59 will have a very thin copper conductor. Also, if the cable has two sides that can be peeled off one from another, it’s more than likely RG-59. RG-6 normally comes as a single cable and the copper conductor is thicker in diameter.
What gauge is RG59 cable?
20 AWG
A conventional RG59 coaxial cable has a 20 AWG (American wire gauge) copper center conductor, and standard RG6 coaxial cable has a larger 18 AWG copper center conductor, allowing it to offer higher bandwidth and more extended distance capacity.
Can I use RG6 instead of RG59?
As you can see, there is very little to no overlap between their usages and no way you can substitute either of them for any purpose. While RG59 cables are cheaper, they can’t be used in place of RG6 cables for radio transmission or broadband internet.
How do you know if you have a RG59?
The other way to tell the difference between coax RG6 and RG59 cable is to compare their diameter. Normally, the outer diameter of RG6 is 6.90mm, while the RG59 is 6.15mm. RG6 cable is thicker than RG59 for it has a thicker center conductor. When you strip out the two cables, you’ll see the clearer difference.
How do I connect my BNC connector to my TV?
Connect to a TV using Video Out connection Simply plug the BNC connector into the Video Out socket on the back of the DVR and then plug the RCA connector into the AV In port on your TV. Once all of the connections are done and you power up your DVR the TV should show the DVR screen.
Can I use RG59 for antenna?
If you have a home pre-wired with RG59 cable, as many were in the late 1990s and early 2000s, it’s perfect for distributing an antenna signal. It won’t work for satellite, but you don’t need to worry at all if you want to get free HDTV throughout your house with an over-the-air antenna.