Why is my kicker amp not working?
If your amplifier does not appear to be working, check the obvious things first such as blown fuses, poor or incorrect wiring connections, incorrect setting of crossover switch and gain controls, etc. There are Power (PWR) & Protection (PRT) LEDs on the side panel of your Kicker CX series amplifier.
Do Kicker amps have fuses?
KICKER® AFS Fuses are platinum plated for maximum current transfer. These high-amp fuses are the best way to protect the investment you have in your sound system. This pair of 60-amp fuses is the perfect way to protect your amps.
What does the PRT light mean on a kicker amp?
Applicable Products and Categories of This Article. The POWER/PROTECT light will change from green to red under the following circumstances: When the car amplifier is overheated (thermal overload). A speaker wire has short-circuited. DC current is generated.
Why am I not getting any power to my amp?
If the Amp Doesn’t Power On at All If the remote turn-on wire doesn’t have power, your amp won’t turn on. This wire is thicker than the remote wire, and it should have battery voltage. If it doesn’t, check for any inline fuses and verify that the wire isn’t loose, corroded, or shorted out somewhere.
How do you know if your amp is blown?
How do you Figure Out that your Car Amplifier is not Working Properly?
- There is a noticeable distortion in the sound.
- There is no sound even if you have already turned on your audio system.
- Your stereo system starts making bizarre sounds such as farting sounds.
How do I reset my kicker amp?
If you change speakers, move the amplifier to another vehicle, or for any other reason you wish to reset the amplifier, press and hold the setup switch for at least 10 seconds until you hear a low tone. This will clear any DSP settings and you ready to start the setup process again.
Why is my amp not getting power?
If the Amp Doesn’t Power On at All To turn on, the amp needs power at both the remote and power wires, in addition to a good ground. If the remote turn-on wire doesn’t have power, your amp won’t turn on. If it doesn’t, check for any inline fuses and verify that the wire isn’t loose, corroded, or shorted out somewhere.
Why is my amp not putting out sound?
If No Sound Is Coming From Your Speakers Simply unplug the RCA cables from each unit and reconnect them with a good set. If the amp drives that, the problem is with the speakers or wiring. If you still don’t get any sound, the amplifier might be faulty.