How do you reset the alarm on a 2004 Honda Accord?
To reset the security system in the 2004 Honda Accord, turn the key in the ignition as if You’re trying to start the engine. It won’t start, so allow the key to end in the ON position. This will allow the dash lights and radio to work. Leave the key like this for 10 minutes.
How to reset my Honda Accord after changing an alarm?
Turn the key to the unlock position. Turn the key to the lock position. Turn the key back to the unlock position. The alarm should now be disabled. Start your Honda Accord’s engine and allow the vehicle to run for at least 10 minutes. This will allow the Accord to reset the alarm.
Where is the reset button on a Honda SRS light?
To do so, you will be “shorting” the system in order to reset the light. Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash.
Can You disable the factory security system on a Honda Accord?
Fortunately, you can adjust the sensitivity or disable the factory security system yourself, and put a stop to the ongoing racket. If you’re uncomfortable playing with wires, find a reputable shop that can get the job done, but also expect to pay a pretty penny. Here’s a DIY guide to successfully disable your alarm.
How do you turn off the SRS light?
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
How can I disable the Honda Accord security system?
There you can lower the sensitivity by adjusting the knob to your preferred setting. Do not set the sensitivity too low or the alarm may not activate at all—even if the glass breaks. Figure 1. Diagram of the Honda Accord’s security system control box. To completely disable the factory security system, simply disconnect the harness that powers it.
To do so, you will be “shorting” the system in order to reset the light. Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash.
When did the Honda Accord alarm go off?
This article applies to the Honda Accord (1990-2002). Despite Honda’s reputation for reliability, certain Honda Accord models also have a tendency to experience security system malfunctions. This can be quite problematic when the alarm randomly goes off at four in the morning, waking up your family and your neighbors.
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.