What can I take instead of Vascepa?
Both medications are similar. Vascepa and Lovaza are both omega-3 fatty acid supplements available by prescription to lower triglycerides. Both medicines contain EPA; Lovaza also contains DHA.
Is Vascepa bad for kidneys?
Treatment with icosapent ethyl (Vascepa, Amarin) 4 g per day did not raise LDL and had no negative effect on renal function.
What is a common side effect of Lovaza?
What are the possible side effects of LOVAZA? LOVAZA are burping, infection, flu symptoms, upset stomach, a change in your sense of taste, back pain and skin rash. Talk to your doctor if you have side effects that bother you or that will not go away.
Can Vascepa cause leg pain?
Common Vascepa side effects may include: muscle or joint pain; constipation; swelling of the hands, legs, or feet.
Can Crestor cause urinary problems?
This medication may rarely cause liver problems. If you notice any of the following rare but serious side effects, tell your doctor right away: yellowing eyes/skin, dark urine, severe stomach/abdominal pain, persistent nausea/vomiting.
What to do when your Vespa engine dies?
Just replace everything you can while you have the carb apart. Run your bike with the gas off until the engine dies. Start by removing the screws arrowed, this will remove the Carb Box cover to reveal the meaty, juicy insides. When you re-tighten these screws, do it evenly to avoid warping.
What causes a soft seizure on a moped?
Soft Seizure. A soft seize is a type of that occurs when there is insufficient lubrication and/or the piston overheats and expands to the point that it gets stuck in the cylinder. It usually frees up immediately or soon after the engine cools.
What to do if your Vespa needle seat cracks?
If there are cracks, you can use anerobic liquid gasket to temporarily fix the crack. Inspect the Float for cracks. If there is ANY gas inside the float, replace it. The float should have squared edges, if there is damage to the needle seat or float, replace the float.
How do you get a float out of a Vespa?
Remove the screws that hold the float cover together (arrowed above) and pull out the float assembly – get a towel ready to soak up some gas. Once you get the float out of the carb body, you will have to push out the pivot pin to get out the float needle. Displace the pin with a bent paperclip and all the stuff will pop into your hand.