How do you fix a stapler problem?
Use a sharp object to push the jammed staple up from the bottom. Any of the following should work: tweezers, scissors, a flathead screwdriver, or needle-nosed pliers. Push the prongs of the jammed staple upward to try and loosen it from the grip of the stapler.
How do you fix a stapler that won’t open?
Hold the top of the stapler magazine with two fingers and slowly, while maintaining firm pressure, start pulling the lid apart from the part of the magazine that holds the staple. Be careful not to do this too quickly, or the lid might again fly open, spraying the staples all over your office or desk.
Why did my stapler stop working?
When any important part is broken or worn out, the tool simply won’t work. Make sure you are using staples of the correct size and type for the tool. Small variances can gum up the works and cause staples to jam or defeat the spring or hammer mechanisms.
Why is my stapler not working?
If nothing is coming out of the stapler at all, a staple jam is most likely the issue. Open the staple gun and remove the bar of staples. A flat head screwdriver or butter knife can often remove visible staples. If the staple cannot be seen, attempt to slide the screwdriver through the feed to dislodge it.
How do you unfold a stapler?
Open the stapler. To open these, grip the base of the stapler, then pull the top of the stapler until it lifts open and the staple tray is revealed. Back load staplers usually have a button on the back, so to open these, push the button until the stapler tray pops out slightly.
Why is my staple gun not firing?
First make sure the staples being used are the correct size for the staple gun. If nothing is coming out of the stapler at all, a staple jam is most likely the issue. Open the staple gun and remove the bar of staples. Slide the spring back and forth to check that the staples are able to freely be forced out.
How do you open a stapler?
Why is my stapler stapling backwards?
The setting most people use is the one that causes the legs of the staple to bend inward to hold a stack of papers firmly together. This is the “staple” or “reflexive” setting. If the user reverses the strike plate, the staple’s legs will splay outwards when they come through the paper. This is the “pinning” setting.
How do you fix a broken stapler?
Grasp the stainless steel part of the stapler with one hand, and the plastic/acrylic top with the other. Pull them apart until you can see the inside of the stapler. Move all of the good staples that you can grab back from the head of the stapler and remove them temporarily.
How do I fix a Staples One Touch stapler?
1 Answer. To fix the Staple’s One Touch Stapler, you must pull the stapler open so it’s at a straight angle. Then look at the picture on the bottom of the stapler. Its’ saying to pull out the black click thing and then (here’s the tricky part) put the staples into the body of the stapler, not the part you just pulled out.
How do you fix a stapler spring?
First pull out the spring assembly. Use a pair of needle-nosed pliers to pull the jammed staples out of the head of the stapler. In a worst-case scenario, it could help to drop the stapler on a solid surface a few times to loosen up the staples.