How do you reset the airbag light on a 2005 Honda Odyssey?
Switch the ignition ON, the SRS light will appear for six seconds then OFF for four seconds. When the light goes OFF, REMOVE the paperclip. When the light comes ON, put the paperclip back IN. Once more, when the light goes OFF, REMOVE the paperclip.
How to reset the SRS light on a Honda Odyssey?
I had to search numerous posts before figuring out everything needed to reset the SRS light on my 2002 Odyssey. I thought it might be helpful to someone else to summarize all that I found in one post… 1. Locate the yellow 2-pin MES Connector on the fuse block above the driver’s kickpanel (two blue wires).
How can I read the OBD code on my car?
Write down the codes as they flash through the “Check Engine” light. Each code has a meaning, directly related to a problem in the engine. Look up the codes in a repair manual. Depress the odometer “Trip” and “Reset” buttons while turning the key “On.” Release the buttons and watch the odometer display for the trouble codes to read out digitally.
How do you turn off the SRS light?
Turn Ignition off; connect the scs tool (jumper wire, paper clip, etc.) 3. Turn ign on (crank up engine) and wait for SRS light to go off. 4. Disconnect the tool (jumper wire, paper clip, etc.) within 4 sec 5. When the light comes on again, reconnect the tool within 4 sec. 6.
Where do you plug in the OBD-II scanner?
Locate the test port under the dash where the OBD-ii scanner plugs in. Use a piece of jumper wire or even an unbent paper clip to link ports “A” and “B,” initiating the diagnostic sequence. Watch the “Check Engine” light for the codes to flash. Take your vehicle to an auto parts dealer for a diagnostic check free of charge.
Is there a wireless OBD scanner for a Honda?
At times stand-alone scanners just don’t cut it. Those are the times when a wireless tool comes in handy. And if you own a Honda, there’s no other wireless OBD scanner that will be as helpful as the BlueDriver LSB2 Honda OBDII Scan Tool.
What is the read and clear code on a Honda?
Read and clear codes. Specifically, the Innova 3040E pulls engine, ABS and EVAP trouble codes in Honda and Acura vehicles. You can diagnose the CEL as well as the ABS light and turn them off. You can also check your car’s emission readiness.
What can you do with an OBD scanner?
Depending on the type of scanner you choose, you may be able to read and clear codes, turn off the Check Engine Light (CEL), view live data, check freeze frame data, perform bidirectional controls & tests, do programming and so much more. The exact range of functions varies from one device to another.
What does a Honda scan tool do for You?
By simple definition, a Honda scan tool is an OBD device that’s made specifically for the Honda brand of vehicles. It lets you scan the on-board systems of your car to identify existing problems, if any.