How do I reset my Hyundai remote starter?
Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.
Why does my remote start not work sometimes?
Cause: It is rare, but does happen – in most cases, this is caused by a dead battery in the vehicle or the battery having been disconnected when being serviced. Remote starters usually have some type of non-volatile memory to retain things like programming features and remote control codes.
Why does my remote start turn off after a few seconds?
The most common reason for a vehicle to start, then immediately shut off is engine checking. If there is something wrong with one of these signals, or they’ve changed; you may need to re-learn your vehicle’s tachometer signal to our unit.
What is valet button on remote starter?
Valet mode is a setting/feature your remote starter has, that allows you to disable the ability to remote start the vehicle. It is designed to be used when you take your vehicle in for service or if you are lending the vehicle out and wish to prohibit (ie turn off) the ability to remote start the vehicle.
Can you add Avital remote start to aftermarket?
Add Avital remote start to any remote system – OEM or aftermarket – in a new, easier-to-install design. If you have an issue with your Avital system, call our toll-free number anytime, even when traveling.
How to get remote starter out of valet mode?
To get the system out of valet mode, try pressing the lock and trunk buttons at the same time for 1/2 a second. Problem solved! Many remote starter systems will use a switch to put the system in valet mode.
What happens when the remote starter does not work?
If they no longer flash when you ask your vehicle to lock or unlock using the remote starter controller, you may be in valet mode. If you can lock and unlock your doors just fine but ONLY the remote start does not work, you may be in valet mode.
Why does my Compustar remote not enter valet mode?
Valet mode is entered by pressing 2 buttons on the remote simultaneously. We have seen this happen accidentally when the remote is in a purse or pocket. If you own a Compustar system and it will still lock and unlock the doors, but it does not flash the parking lights and the remote starter stopped working, this may be the culprit.