Why is my radiator fan not turning on?
The computer sends power to the relay to activate it and turn the fan on. Once activated, however, if the relay sticks in the closed position then the fan will run until the battery is totally discharged.
What happens when you turn off the cooling fan?
At stops the engine shut off as expected. Cooling fan continued to run. When she arrived at her destination she turned the vehicle off. Cooling fan continued to run. She called me. I told her to hang around for five minutes to see if it would stop after a period of cooling down.
How does a radiator fan work when the AC is on?
The electric radiator cooling fan assembly is controlled by a thermoswitch located in the side of the radiator. At higher coolant temperatures, the switch closes to start the cooling fans. Any time the coolant temperature rises to higher than normal levels, the fan will start and continue to run until coolant temperature returns to a normal range.
What to do if your engine fan won’t turn off?
13 people found this helpful. If the fan switches off by itself after about 10 minutes, it is working properly. MK4 (1999-2004.5) VWs have an after run feature to cool the engine after shut down if the coolant temperature is too high. 36 people found this helpful.
Why are my radiator fans not turning on?
Unplug the coolant temperature sensor while the engine is running. This should cause the fans to turn on low then kick to high, IIRC. Typically when the engine computer loses the signal from the coolant temp sensor, it just turns both fans on high so the engine will not overheat. IIRC if you ground the gauge wire, the gauge should go to full scale.
How do you remove a plug from a radiator fan?
Lift the clip before pulling the male and female plug housings apart, if your plug is so equipped. Use the blade of a slotted screwdriver to lift the clip if you are unable to pull it up with a finger. The plug carries all electrical connections to the fan.
Where is the electrical plug on a radiator?
Locate the electrical wiring plug connector on the radiator fan. The plug is typically mounted on the lower end passenger side, but may be connected at the center of the fan hub. Check the connector plug for a clip extending from the male end of the plug to the female end, which is secured on the fan shroud. Not all connector plugs have such clips.
What happens if the coolant fan switch does not work?
Engines generate an enormous amount of heat and as a result are subjected to very large temperature swings if this switch does not operate effectively. When this happens, the result can be extremely damaging, resulting in thousands of dollars in engine damage.
Although the fan itself can go bad, that’s definitely not the place to start a diagnosis. Here are the most common reasons that your radiator fan does not turn on: Before poking your hands around your fan, make sure to treat it like it still could come on, and and keep your hands out of its path.
Can a radiator fan and condenser fan share a relay?
There are, however, some models that use a dedicated second unit to the condenser. In such a scenario, the condenser fan and radiator fan may or may not share the same relay. If the cooling fan does not engage, you can check whether the relay is to blame by swapping it out for a different relay.
What causes a cooling fan relay to stop working?
Cooling fan relays can stop working for any number of reasons. Common causes for relays going bad include: There are several ways to tell if a bad cooling fan relay is to blame for an overheated engine. The easiest method is to start the engine and then turn on the air conditioning.
Why is the radiator fan not working on my Ford Escape?
If your Escape has a bad engine temp sensor the radiator fan won’t know to come on, because the ECU won’t know how hot the engine is. You’ll need to locate and test the engine temp sensor.
Why is my Honda radiator fan not working?
If the radiator fan begins working, this is an indication that the fan relay is bad. If the fan switch relay is giving off the appropriate readings and is in working condition, move on to the next step. The thermo switch (also called the cooling fan switch) sends a signal to the cooling fan, so the fan turns on if the coolant gets too hot.
How can I tell if my radiator fan relay is bad?
Another easy way you can check if the radiator fan switch relay is bad is to swap the radiator fan relay with the condenser fan relay. If the radiator fan begins working, this is an indication that the fan relay is bad. If the fan switch relay is giving off the appropriate readings and is in working condition, move on to the next step.
There are, however, some models that use a dedicated second unit to the condenser. In such a scenario, the condenser fan and radiator fan may or may not share the same relay. If the cooling fan does not engage, you can check whether the relay is to blame by swapping it out for a different relay.
What does it mean if your Radiator is not working?
If the radiator fan is not working, it’s a serious problem. Just because the radiator fan is not on does not mean that it is not working. They are designed to only run when needed.
What to do if your cooling fan won’t stop running?
The fan will discharge the battery quickly if left running. Open the hood and locate the fuse relay box on the driver’s fenderwell. Remove the lid. Look on the inside of the lid and for the mapping of the fuses and relays with their location. Pull the cooling fan relay out of the box. Replace the cooling fan relay with a new one.
Why does my Jetta not have a cooling fan?
Simply the engine is not hot enough to turn on the cooling fan, its not hot enough outside, you are driving getting plenty of air flow through the grille to keep things cool without the assistance of the fan. Its possible that you have no problem at all. Was this answer helpful? I got a 2002 Jetta the cooling fans don’t turn on .
Why is the radiator fan not working on my Jeep Grand Cherokee?
Remove a known good relay and swap it with the radiator fan relay. Operate the vehicle and check the operation of the unit replaced. If the unit works with the fan relay it proves that the relay is not the problem. Test the relay using jumper wires and a voltmeter.
What makes the radiator fan turn on or off?
A radiator temperature-sensing switch activates the fan relay at 198 degrees F turns the fan on and controls its operation. Make sure the key is off. Switching relays is the fastest way to check for a bad relay when possible.
Where is the relay on a Jeep Grand Cherokee?
A Jeep has more than one relay that are the same (go by the relay number on the top or side of the relay) in the fuse box on the driver’s side fenderwell. Remove a known good relay and swap it with the radiator fan relay. Operate the vehicle and check the operation of the unit replaced.
How can I tell if my radiator fan is bad?
Check the radiator fan switch if the relay proves to be good. If the fan switch is good, check the radiator fan by using the jumper wires from the battery to the electrical connection on the radiator fan to wire it directly to the battery. If it fails to operate the fan is bad. 25 people found this helpful. 19 people found this helpful.
There are a few common reasons why your radiator fan is not turning on. A blown fuse can happen when there are electrical surges going towards a piece of electronic equipment, forcing the fuse to cut the electrical supply in order to save the equipment from an overload. Despite a blown fuse not being a big issue, it is important to find and fix.
Why does my car’s cooling fan keep coming on?
Answer: Usually, a problem with a relay or module in the circuit would cause the cooling fan to stay on. If you already replaced the relay, check the module, if your model has one. You may need to locate a grounded wire in the circuit.
Why is your radiator fan not running?
The most common causes when a radiator fan is not coming on is broken fuse, bad wirings, bad coolant temperature sensor, bad fan relay, or a faulty radiator fan . Here is a more detailed list of the most common causes of a radiator fan not coming on.
Why does radiator fan not working?
- the first thing to check is the fuse. If you don’t know where the…
- check the fan wires. Start by unplugging the wires.
- Temperature Sensor. The temperature sensor determines when the radiator fan comes on by reading the cooling system…
- Coolant Level. Check the coolant level in your engine. The simplest way to do this is to look at the reservoir in the…
Why is the cooling fan not working?
If you think the cooling fan isn’t working because your temperature gauge is indicating overheating , open the hood, start the engine, and let it idle for 15 to 20 minutes. If the fan comes on, you may have a bad temperature sensor or gauge .
What is the best radiator fan?
List of Best Electric Radiator Fan in 2021 UPGR8 Universal 12 Inch High-Performance Slim Cooling Fan, (Black) We finalize our review with this High-Performance Slim Cooling Fan by UPGR8. AUTOSAVER88 High Performance 16 inches Cooling Fan Black Electric Radiator. AUTOSAVER88 12 inches Electric Radiator High-Performance Cooling Fan.
Why does my car fan keep running after I Turn Off the engine?
Running cooling fans help cool down the engine even after you turn off the car. Common Causes. If your cooling fan runs for over 10 minutes after turning off the engine, you may have a problem that needs to be fixed. Here are some possibilities causing the fan to stay running longer. low coolant level, faulty coolant temperature sensor,
Why are my cooling fans running at all times?
3. Cooling fans stay on at all times. If the cooling fans are staying on at all times, this is another (less common) symptom of a possible problem with the cooling fan relay. If the relay shorts internally, it may cause power to be permanently switched on, which will cause the fans to run at all times.
Why do you need a radiator fan in a car?
To stop the engine from overheating, we take the help of coolants that flow through a radiator into the engine. The radiator’s job is to keep the coolant cool so that when it returns back into the engine, it is able to absorb more heat. A radiator fan is thus used to keep the temperature of the coolant in check. Thus, it has an important job.
Why does the radiator fan run all the time?
The radiator fan may run up to five minutes and sometimes longer. Unless there is an electrical issue, it may stay on all the time until it drains the battery. When the engine is running, the coolant circulates from the engine and flows to the radiator, where heat is dissipated.
When does the coolant fan run in a car?
The coolant fan will run when the coolant exceeds a certain temperature irrespective of if the engine is running or not. Some vehicles even have supplementary electric water pumps set to run after engine shut down to keep coolant circulating.
Why is my water pump and thermostat not working?
The radiator, water pump, and thermostat are definite possibilities, but there are a few others that are possible also. A faulty cooling fan is the first thing that comes to mind, but it could also be a head gasket issue, clogged coolant passages inside the engine, or faulty radiator hoses.
Where is the relay on a radiator fan?
The fan relay is often located in the engine bay’s fuse box, but the best way is to check your repair manual to find where it is located. Testing a 4 pin relay is often very straightforward. Remove the relay and give 12 volts to pin 30 and 85. Ground pin 86 and check if there is voltage coming out from pin 87.
What are the symptoms of a bad cooling fan relay?
1. Engine running hot One of the first symptoms commonly associated with a bad or failing cooling fan relay is an engine that runs hot or overheats. If you notice that your engine is running at higher temperatures than normal, that may be a sign that the relay is not functioning properly.
The computer sends power to the relay to activate it and turn the fan on. Once activated, however, if the relay sticks in the closed position then the fan will run until the battery is totally discharged.
To stop the engine from overheating, we take the help of coolants that flow through a radiator into the engine. The radiator’s job is to keep the coolant cool so that when it returns back into the engine, it is able to absorb more heat. A radiator fan is thus used to keep the temperature of the coolant in check. Thus, it has an important job.
The fan will discharge the battery quickly if left running. Open the hood and locate the fuse relay box on the driver’s fenderwell. Remove the lid. Look on the inside of the lid and for the mapping of the fuses and relays with their location. Pull the cooling fan relay out of the box. Replace the cooling fan relay with a new one.
The fan relay is often located in the engine bay’s fuse box, but the best way is to check your repair manual to find where it is located. Testing a 4 pin relay is often very straightforward. Remove the relay and give 12 volts to pin 30 and 85. Ground pin 86 and check if there is voltage coming out from pin 87.