How do you use autopage remote start?

How do you use autopage remote start?

KE-155R

1. Enter your vehicle and close the doors and trunk behind you.
2. Insert the key into the ignition and switch it from “Off” to “On” three times, ending in the “On” position after the third cycle.
3. Push the valet switch on your Autopage alarm twice.
4. Press any button on your keyless remote starter.

What is the valet switch on autopage?

The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode. 1.

How do I turn off autopage alarm?

Programming Alarm Features

1. Press the unlock button on the remote transmitter to disarm the alarm.
2. Open the driver’s door.
3. Insert the key into the ignition.
4. Press the “I” and “II” buttons within 15 seconds to select the feature to program.
5. Push the “I” or “II” button to enable or disable each feature.

Why is my automatic car starter not working?

Cause: It is rare, but does happen – in most cases, this is caused by a dead battery in the vehicle or the battery having been disconnected when being serviced. Remote starters usually have some type of non-volatile memory to retain things like programming features and remote control codes.

How do I take autopage out of valet mode?

Push and hold valet switch for 2 seconds; the LED will turn off indicating the system is exiting the valet mode.

How do I get Excalibur out of valet mode?

How to Exit Valet Mode

1. Insert your vehicle’s key into the ignition and turn to the “ON/RUN” position. Do not crank the engine.
2. Press and release the LOCK and TRUNK buttons (I & III) simultaneously.
3. Remove the key from the ignition and attempt to remote start your vehicle.

How do I change the time on my Viper key fob?

Viper Support Center

1. F-button for setup menu.
2. Press and Release F-button to select remote set up.
3. Use Remote Start Button to scroll to Clock Set.
4. Press F Button again to select it.
5. Set Hour press and release F button.
6. Use Remote Start and Aux buttons to change the hour.
7. Press the F-button to Save.

How do I reset my automated remote starter?

Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.

Why is my push to start not working?

A bad starter won’t be able to crank your engine. If you suspect that you have a bad starter, attempt to jump it directly. After doing so, if the starter still won’t crank your engine, you may need to replace the starter or get a new solenoid, module, or relay.