Where is the evaporator drain tube on a Honda Accord?

Where is the evaporator drain tube on a Honda Accord?

Figure 1. The evaporator is located on the passenger’s side. Figure 2. Tape the rubber hose to the vacuum hose. The drain tube is located underneath the glove box compartment. It is a black rubber hose in between two bolts. Tightly grip the hose, and pull it towards you. It should come straight out. Figure 3. Location of the evaporator drain tube.

Where is the trouble code located on a Honda Accord?

Insert the jumper wire in the 2 PIN service connector between pins 1 and 2. You should also see a 3 PIN connector. This is used for a trouble code scanner. Trouble codes will be stored in the ECU even if the check engine light is not on.

How do you unclog an A / C unit in a Honda Accord?

Connect the drain tube hose to the vacuum. Disconnect the vacuum hose from the drain tube. Start your car, and let it run for a couple minutes. Finally, turn on your A/C to make sure that cold air is coming out. Figure 6. The unclogged evaporator may leak water.

Where is the OBD plug on a 1991 Honda Accord?

The connector may be blue or yellow in color. If the connector has not been used before, you may find it still taped or strapped to the main wiring harness going to the ECU (engine control unit). Insert the jumper wire in the 2 PIN service connector between pins 1 and 2.

The connector may be blue or yellow in color. If the connector has not been used before, you may find it still taped or strapped to the main wiring harness going to the ECU (engine control unit). Insert the jumper wire in the 2 PIN service connector between pins 1 and 2.

Insert the jumper wire in the 2 PIN service connector between pins 1 and 2. You should also see a 3 PIN connector. This is used for a trouble code scanner. Trouble codes will be stored in the ECU even if the check engine light is not on.

What should I do if my freeze plug is leaking?

When a leaking freeze plug is found, the engine should be checked for damage and antifreeze checked for the proper mixture and freezing point. However, freeze plugs can also start to leak over time simply due to the heating and cooling cycles of driving your car.

Why does my freeze plug crack on my car?

In the case of the water jacket in your engine block, this is more than enough pressure to cause it to crack destroying your engine. The engine in your vehicle also has a secondary line of defense against freeze damage, freeze plugs. Freeze plugs are usually aluminum or brass plugs pressed…

Where to buy Honda Accord a / c hose assembly?

Shop AutoZone for Honda Accord A/C Hose Assembly. 10% OFF $75. Use Code: DIYSAVE10 Online Ship-to-Home Orders Only

How does the a / C system in a Honda Accord work?

Your A/C may not be in the best shape to perform. As air runs through a series of tubes and components of the A/C system, the evaporator removes hot air from inside the cabin to turn it into frigid, cool air. During that process, the evaporator also produces condensation, which is then dripped through a tube and released underneath the car.

Figure 1. The evaporator is located on the passenger’s side. Figure 2. Tape the rubber hose to the vacuum hose. The drain tube is located underneath the glove box compartment. It is a black rubber hose in between two bolts. Tightly grip the hose, and pull it towards you. It should come straight out. Figure 3. Location of the evaporator drain tube.

Shop AutoZone for Honda Accord A/C Hose Assembly. 10% OFF $75. Use Code: DIYSAVE10 Online Ship-to-Home Orders Only

Connect the drain tube hose to the vacuum. Disconnect the vacuum hose from the drain tube. Start your car, and let it run for a couple minutes. Finally, turn on your A/C to make sure that cold air is coming out. Figure 6. The unclogged evaporator may leak water.

Your A/C may not be in the best shape to perform. As air runs through a series of tubes and components of the A/C system, the evaporator removes hot air from inside the cabin to turn it into frigid, cool air. During that process, the evaporator also produces condensation, which is then dripped through a tube and released underneath the car.

What happens when you unclog the evaporator on a Honda Accord?

During that process, the evaporator also produces condensation, which is then dripped through a tube and released underneath the car. This system can sometimes become clogged, resulting in blazing hot air. To unclog it, follow these easy steps.

What to do if your Honda Odyssey has a leak?

When the air conditioner in your 2002 Honda Odyssey starts blowing hot air, you likely have a freon leak. Recharging the freon in your AC system is an inexpensive and easy first step to restoring the cooling capacity of your A/C system. Most refrigerants include a leak sealer that will seal small leaks in addition to filling the R134a refrigerant.

What should I do if my AC evaporator is leaking?

If a leak is detected, replacement of the entire AC evaporator is the correct course of action. Some shade-tree mechanics attempt using a sealant to fix a leak, but this is always a temporary solution, and typically creates additional problems with the AC system — so we don’t recommend this type of quick-fix.

During that process, the evaporator also produces condensation, which is then dripped through a tube and released underneath the car. This system can sometimes become clogged, resulting in blazing hot air. To unclog it, follow these easy steps.

Why is my Honda Element EVAP stuck closed?

In this short 2mins video on a Honda Element 2004 2wd DX, I go over a Trouble Diagnostic Code P2422 EVAP CVS Stuck Closed. Upon inspecting the Evap Components a Yellow Sac Spider’s Nest inside the breather vent which had obstructed the flow. I cleaned and reinstalled the breather, cleared the code and solved the problem. Loading…

What to do if your Honda Odyssey breaks down?

It is also amongst the most common causes for a break down in transmission. To check your car’s fluid level, warm your Honda Odyssey by taking a short drive. Then open the hood and read dipstick levels. Transmission fluid does not burn off, so if you record a low level then there is a tendency of leakage, and it requires patching up.