How do I fix error code P1345?
Loose the distributor hold down bolt with engine OFF. Make sure your OBD scanner is plugged in to monitor the Cam Retard Offset reading. Turn the engine on, let it warm to normal operating temps, and get the rpm’s above 1,000. If your reading is negative, turn the distributor counterclockwise.
What does a P1345 code mean?
Error Code P1345 is defined as Crankshaft Position-Camshaft Position Correlation. This error code is a manufacturer-specific trouble code, meaning it does not apply to all vehicles makes. Rather, it applies only to specific vehicle makes, such as Audi, GM (Chevrolet/GMC), Isuzu, Lexus, Mazda, Toyota, and Volkswagen.
What does camshaft to crankshaft position correlation fault mean?
The error code P0016 is triggered when the bank 1 camshaft position sensor doesn’t match the signal from the crankshaft position sensor. This can cause various issues with the overall functioning of the engine and can lead to increased fuel consumption and rough engine idling.
What happens if your camshaft position sensor goes bad?
A failing camshaft position sensor begins losing its ability to quickly transfer data. Mismatched fuel delivery and ignition timing, even if off by a few milliseconds, will cause your vehicle to sputter, accelerate poorly, lack power, stall or even shut off.
Can you clean camshaft position sensor?
Spray a small amount of solvent on the sensor. Wipe it dry with another rag. Replace the camshaft sensor, and tighten the screws. Attach the three wires back into their original positions, and connect the negative battery cable.
Can bad oil cause P0016?
In the absence of serious engine issues, the P0016 OBD2 code can also be caused by dirty oil or using oil with the wrong viscosity. Since the camshaft phaser relies on oil pressure, clogged passages due to dirty engine oil will result in a stuck phaser and bad engine timing.