How do I set a default route in EIGRP?
One way to inject a default route into EIGRP is to configure a static default route pointing to Null0 and then redistribute the default route into EIGRP. When redistributing a static, connected, or EIGRP route for another AS, the metric does not need to be assigned. The default route will be an external EIGRP route.
How do I set default route in IPv6?
To view the default route in the routing table, use show ipv6 route ….Syntax.
| ::/0 | Specifies the default IPv6 route. |
|---|---|
| ipv6-gateway-addr | Specifies the next-hop router for traffic sent to the default route. |
| distance 1 – 255 | Specifies the administrative distance to associate with a static route. Default: 1; Range: 1 – 255 |
Does EIGRP work with IPv6?
The network command is not used in IPv6; EIGRP is configured via links. The ipv6 keyword is used in many of the EIGRP commands. Needs to be explicitly enabled on each interface when configuring EIGRP.
What is a default route in Cisco?
Default route which is also known as the gateway of last resort, is used in forwarding packets whose destination address does not match any route in the routing table. A default route is very useful in network where learning all the more specific routes is not desirable such as in case of stub networks.
What is the default metric for EIGRP?
Default Seed Metric Interestingly, both RIP and EIGRP have default seed metrics of infinity, meaning that any route redistributed into those routing protocols will be considered unreachable, by default, and therefore not advertised to any other routers.
How set IPv6 default gateway Cisco?
Configuring IPv6 Default Gateway and Static IPv6 Routes
- In the Managed Network node hierarchy, navigate to the Configuration > Interfaces > IP Routes tab.
- Click + under the Static Default Gateway accordion.
- Select IPv6 from the IP version drop-down list, and enter the IPv6 address in the IP address field.
Why default route is needed?
Understanding how and when to use default routes is imperative to proper network setup. Without a default route, a router will drop a request for a network that isn’t in its routing table and send ICMP Destination Unreachable to the source of the traffic. Here’s a simple example: Our PC has an IP address of 192.168.
How is EIGRP for IPv6 configuration done?
Configure the EIGRP for the IPv6 routing:
- Enable the IPv6 routing on a router.
- Assign the router ID of the each router.
- Enable the EIGRP for IPv6 routing on every router.
- Configure the EIGRP for IPv6 by using the AS 1 on a gigabit Ethernet and serial interfaces on a router.
- Determine a neighbor adjacency.
Which multicast address does EIGRP for IPv6 use?
FF02::10
EIGRP for IPv6 uses multicast like EIGRP (for IPv4) to communicate between local EIGRP neighbors; the multicast address used is referred to as the All EIGRP routers address of FF02::10 (very similar to the previous 224.0. 0.10).
What is default route configuration?
In computer networking, the default route is a configuration of the Internet Protocol (IP) that establishes a forwarding rule for packets when no specific address of a next-hop host is available from the routing table or other routing mechanisms.
How do I set a default route in Cisco?
Perform these steps to configure a default route.
- Enter global configuration mode. device# configure terminal.
- Enter 0.0. 0.0 0.0.
- (Optional) Enable the default network route for static route next-hop resolution.
- (Optional) Configure next-hop recursive lookup to resolve the next-hop gateway.