What does a 2 inch drop spindle do?
Drop-spindles relocate the shaft to a higher position, typically 2-3 inches higher than the original. Doing this allows your wheel to be higher in the fender well, thus lowering your truck. Installing drop-spindles allows you to continue to use the vehicles factory spring and shocks.
Do you need drop shocks with drop spindles?
No. You do not need to use a drop shock when using 2” drop spindles because the spindle shaft and the pickup points for the caliper have been moved up. A stock or aftermarket lowering spring makes for a shorter height and therefore you need a shorter compression on the shock. …
Do drop spindles change geometry?
People use drop spindles to alter geometry by changing the suspension’s resting position with a different spring or shock length, and then using a drop (or lift) spindle to compensate for the ride height change, basically allowing you to shift the camber curve up or down.
Are drop spindles legal?
Drop spindles are legal , and are probably one of the best items to come out of CRS , I think theres a mob called Stubtech making them now …
What’s better drop spindles or lowering springs?
To answer the original question spindles “technically” should ride better than drop springs. Reason being is a 2″ drop spring will give you 2″ less of uptravel until you bottom out. Spindles keep the same uptravel. From experiance 2″ drop springs aren’t going to hurt your ride that bad.
How do you know if you have drop spindles?
If the spindle snout is near the bottom ball joint tang, then it’s a stock spindle. If the snout is about mid-way between both upper and lower ball joint tangs then it’s a drop spindle. Also, drop spindles have a very smooth casting, stock spindles are very rough in comparison.
Do you need an alignment after drop spindles?
You will need an alignment after spindle install.
Are lowering blocks legal NSW?
Under current NSW law a vehicle’s suspension can be raised or lowered by up to five centimetres without an engineer’s approval, and by up to 15cm with an engineering certificate.
Can you lower cars in Australia?
If a car doesn’t meet those rules they’re not even allowed to be sold in Australia. For lowering or raising suspension, you can do so by no more than one-third of the original suspension travel that was set when the car was manufactured. There is a 50mm limit to this.
Are drop spindles good?
Q. Why is a drop spindle a better choice than using a drop spring? A. By using a drop spindle you will be maintaining a factory ride quality. Lowering springs are usually rated higher than stock springs depending on the amount of drop, taking away from the factory ride.
Can a dropped spindle drop a front suspension?
IF you want a stiff ride like i posted up here use the summit sport shocks they are the same as the doetsch tech. Most dropped-spindle manufacturers can drop your stock front suspension approximately 2 inches with the simple addition of a dropped spindle, without cutting or replacing the coil spring.
Which is better a drop coil or spindle?
A drop coil is designed for a specific vehicle weight and to perform at a pre-determined ride height. A spindle needs to be designed around the given drop height while caster, camber, bump steer, etc is taken into consideration for optimal performance. To answer the original question spindles “technically” should ride better than drop springs.
What happens if you drop a spindle on a GMC Truck?
A problem with a dropped spindle is maintaining the proper suspension geometry and the proper clearance between the lower control arm and the wheel when it is turned to a full-lock position.
What’s the difference between spring and spindle on a Chevy truck?
Generally, the tighter the windings, the softer the spring rate. This means that the first few inches of travel will be fairly soft, for around-town driving, but when compressed further as your driving style becomes more aggressive, the spring rate will increase.