What does it mean when your alarm system says trouble?
A trouble signal (sometimes indicated in the alarm history by the abbreviation TR) indicates a possible problem or difficulty with your security system, such as a loose wire, a poorly aligned sensor or a low battery status.
What is one of the main problems with alarms?
The main problems found with alarms are that they can often be too loud and shrill (because they are usually installed on a ‘better-safe-than-sorry’ logic) with the risk that they are turned off because they are so irritating, there are usually too many of them, they are often difficult to tell apart from one another …
What can trigger an alarm?
Also, faulty or loose contacts on your windows or doors can trigger false alarms. In fact, any external elements that get in through loose cracks on doors or windows, like rain or wind, can set off alarms. Balloons, plants, and other moving objects near motion sensors could trigger the sensors and set off the alarm.
What can trigger a security alarm?
If you don’t fully secure windows and doors before arming your system, it could cause the system to trigger a false alarm. Some security products are very sensitive, so anything that disturbs a window or door (even wind or rain) can trigger an alarm.
How do I turn off my alarm system?
You can turn off or power down your home alarm system by disconnecting its backup battery and then unplugging the transformer for the device from the wall outlet. You can confirm that the panel has been powered down by checking its touchscreen or keypad and making sure that it is blank.
What causes a lit trouble light on my alarm system?
While the the possible causes of a lit trouble light are endless, the most probable cause and solutions are outlined here: Normal control panel battery life is 2-5 years. Replace the battery in the control panel. Control panel outage, power outage to the house, loss of power to plug, transformer for the system is dead.
What causes an alarm system to go out?
Replace the battery in the control panel. Control panel outage, power outage to the house, loss of power to plug, transformer for the system is dead. Check the plug that the system transformer (a little 3″x3″ cube) is plugged into.
What to do if your home alarm system has lost power?
If your system keypad indicates that it has lost power, but to your knowledge you have had no power outages, please follow these steps: Note: It is recommended that you contact the Monitoring Center and put your system in test mode prior to unplugging the power source from the outlet.
What to do if your home security system is having trouble?
Reset power; all should go back to normal (unless the transformer for the system went bad – If that happened, you’ll need a service call.) Traditional “land line” systems are always looking for dial tone to control panel. If the house phone is dead this trouble condition will exist.