Do you need a wiring diagram for a Jetta 2012?
I need a wiring diagram for a Jetta 2012 1.6 TDI. I have a car with me that gives me error P0237 (Manifold Pressure / Boost Sensor (G31): Signal too Low) I did change the sensor and it stay the same. I also noticed that the sensor plug was a bit broken on the harness and that it was plugged in wrong way around.
What should I look for in a VW Jetta?
(09-25-2016, 10:34 PM)Bogdan Beb Wrote: If the error it’s active, with ignition on and you have +5V , ground and signal (above 1,7) ok, probably you need to check further. But if the error occurs when the engine runs, check the value of pressure at idle, maybe value greatly decreases, in this case take a look at egr, intake flap.
Can a VW Jetta be shorted to the G31?
Pull off the connector G505, it can not be shorted to the G31. If I helped You,just press Thanks and Rep. ! If the error it’s active, with ignition on and you have +5V , ground and signal (above 1,7) ok, probably you need to check further.
What kind of engine does a Volkswagen Jetta have?
If you’re looking for better understanding of your A5 platform Jetta, look no further than Bentley. Engines covered: • 1.9L TDI PD diesel (engine code: BRM) • 2.0L FSI turbo gasoline (engine code: BPY) • 2.5L gasoline (engine code: BGP, BGQ) Transmissions covered: • 04A 5-speed manual • 02Q 6-speed manual • 09G 6-speed automatic • 02E 6-speed DSG
Is there a service manual for a Volkswagen Jetta?
Service to Volkswagen owners is of top priority to Volkswagen and has always included the continuing development and introduction of new and expanded services. Whether you’re a professional or a do-it-yourself Volkswagen owner, this manual will help you understand, care for, and repair your Volkswagen.
How many ohms does a VW Jetta have?
Contact 1 + socket 72 Contact 2 + socket 73 Contact 3 + socket 36 Contact 4 + socket 35 Contact 5 + socket 33 Contact 6 + socket 34 Wire resistance: max. 1.5 Ohms – Additionally check the wiring for short to battery positive or Ground. – Additionally check wires for short to one another.
https://www.youtube.com/watch?v=Yc_-7UsTpMQ