How to change fuel pump timing on Golf Jetta Beetle?
Insert fuel pump locking pin/tool #3359 into hole in fuel pump toothed pulley and then thru hole in fuel pump casting. It is possible to install pin/tool 3359 to the right of the hole and have the injection timing off by about 30 degrees. If this is done your engine will not start.
How to remove the injection pump on a Volkswagen Jetta?
ALH engine VW TDI injection pump removal and replacement How to remove the injection pump on your Volkswagen TDI Reinstalling your Volkswagen Jetta, Golf, or New Beetle ALH engine fuel pump (IP), Part 2 back to part 1 Also review ALH timing belt part 2 – installationto make sure you understand what you are doing.
Where to put timing belt on injection pump?
* Place the timing belt onto the injection pump sprocket and tensioning roller, and thread under the idler roller. The camshaft sprocket may need to be removed (loosen the 19mm bolt all the way) to get the timing belt on.
Can a timing belt be repaired on a VW?
DISCLAIMER: The 1.9L ALH TDI VW timing belt installation is a complex repair procedure and should be performed by experienced automotive technicians, trained in performing proper timing belt installation. Blauparts recommends that an Audi VW Factory Trained ASE Certified Technician perform timing belt repair.
How do you install a new water pump on a Golf Jetta?
Install the new improved water pump by turning all water pump fasteners equally snug by hand and then slowly and evenly torque the fasteners to 7 ft lbs. Use a pliers to loosen the hose clamp at the thermostat housing and remove hose.
Where to find alignment mark on camshaft sprocket?
The camshaft sprocket alignment mark is visible through the opening in the front distributor housing cover just above the distributor cap. When the letters “OT” are visible in the window, continue to rotate the engine clockwise until the scribe mark (line) beside the “OT” is aligned with the tab inside the window.