How do you turn off the passenger airbag in a Chevy Colorado?

How do you turn off the passenger airbag in a Chevy Colorado?

First, put Your key into the ignition, and turn it to the “on” position. Make sure You don’t actually start the car at this point. Next, count to seven, and the airbag icon should go away. When it does, quickly turn the ignition back off.

How do you turn off the passenger airbag in a Chevy Silverado?

How to Disable the Silverado Airbag

1. Turn off the engine and take the key out of the ignition. Place the transmission in park and apply the parking brake.
2. Insert the key into the passenger airbag “ON/OFF” switch. Turn the key to the “OFF” position and remove the key from the switch.

How do you reset an airbag?

How to Reset an Airbag Light

1. Put the key into the ignition and turn the switch to the “on” position.
2. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
3. Repeat Steps 1 and 2 two more times.

How do you reset the airbag light on a Chevy?

How to Reset Airbag Light on a Chevy

1. Under your Chevrolet dashboard, you will find the Onboard Diagnostic port, also known as the OBD-II port.
2. Plug your Chevrolet Airbag Scan Tool into the 16 pin OBD2 port.
3. Turn on the ignition.
4. Allow your Chevrolet airbag scanner to power on.

How do you turn the passenger airbag off in a Suburban?

How to Disable Airbags in a Suburban

1. Turn off the engine and place the Suburban’s transmission in park.
2. Locate the engine bay fuse block.
3. Remove the cover from the fuse block.
4. Remove the airbag fuse from the fuse block.
5. Turn on the ignition and verify that the airbag warning lamp is illuminated.

How do I manually turn off the passenger airbags?

There is a slight chance a hard crash could set off the airbag no matter what, and a rear-facing car seat sits far too close to the passenger side airbag. If your vehicle does not have this switch in the glove compartment, then it has a sensor responsible for automatically turning the passenger side airbag on and off.

Can a rear-facing car seat set off an airbag?

There is a slight chance a hard crash could set off the airbag no matter what, and a rear-facing car seat sits far too close to the passenger side airbag. If your vehicle does not have this switch in the glove compartment, then it has a sensor responsible for automatically turning the passenger side airbag on and off. Was this answer helpful?

Why is my passenger airbag off light turned on?

This can turn the airbag off for similar reasons. The weight sensor doesn’t know if it’s your belongings, a dog or another passenger that is occupying the seat. If what you have there is heavy enough to set off the sensor, then it will assume that it could be a lightweight person.

How do you remove an SRS airbag warning light?

Hold the center section of the wheel in place — where your airbag is located — and locate the screws. Unscrew them. Step 3: Once the screws have been unscrewed, pull the airbag towards you and remove the connectors. Use a pick to slide the yellow clips out in order to remove the connector. You can now remove the airbag.