How do you reset the ABS light on a VW?
Resetting Your ABS Dashboard Warning Light Step One: Disconnect the positive cable from your car battery. Then, hold down the brake pedal to drain the vehicle’s electrical system. This will result in a reset of the car’s central computer. Plug the cable back in to restore power.
Why is my ABS light on in my VW?
When your Volkswagen’s ABS service light is on, your antilock system has been deactivated due to a malfunction. ABS will usually intervene by rapidly pumping the brakes at the wheel that is locking up, allowing it to spin so that the driver retains braking and steering control.
Where is the ABS light on my car?
An ABS light (anti-lock braking system) that is stuck on doesn’t necessarily mean you need an ABS brake repair. The light is generally located on the dashboard on your control console next to the speedometer and gauges, and it could be triggered by issues other than problems with the anti-lock brakes.
How to erase ABS light trouble codes on a VW?
Loosen the retaining nut on the cable that runs to the VW’s negative battery terminal. Slide the cable clamp off the negative battery terminal. Wait one to two minutes. This will reset the ECU and begin the process of erasing the trouble codes.
What to do when your abs warning light goes off?
Once you have determined you are going to fix the problem, park the car on level ground with the transmission in park and the emergency brake set with the engine turned off. You may need to jack the car up to remove a tire or replace a control module. Always stay safe by using jack stands when lifting a car for repairs.
Why is my ABS brake light not working?
An error occurred while retrieving sharing information. Please try again later. If you have the old-style ABS brakes with the metal ring, it’s a possibility you might have damaged the ring when you replace the wheel bearing or installed the sensor improperly. Also, check the sensors for debris build-ups like road grime or axle grease.