Why does a throttle body relearn?
Idle Relearn (aka throttle body relearn) is the procedure that is required to obtain the correct idle speed after replacing electronic throttle body, disconnecting a battery cable, clearing a check engine light, etc. The symptoms are, idle is too low, too high, or erratic.
How do I reset my throttle body GM?
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds.
What happens when the ETS light comes on?
By the time the ETS light comes on your dashboard, and the car goes into “limp home mode,” the throttle has totally failed, though turning off the engine and restarting it will often clear the ETS light and enable you to drive normally for a short time. 1.
What does electronic throttle control ( etc ) light mean?
Electronic Throttle Control (ETC) Light – Meaning, Function & Causes Back in the day, your vehicle’s throttle body had a wire that connected to the pedal. When you pushed the pedal, you opened the throttle body, and you increased the amount of air that enters your engine.
How does the throttle position sensor work in a car?
A throttle position sensor is similar to the motor cortex in the human brain, it controls one of the most important components of the car that keeps your engine running like a throttle body. Picture a little module in the car that reads how far down you have pressed the gas pedal.
Why does my throttle control light not work?
You will feel a weak throttle response and at times a jitter before your car accelerates. One way that can happen is when the ETC is not getting proper electronic signals from the gas pedal. The ETC works great only when it receives proper signals. It is possible that a relay has gone bad or a wire has been cut loose from the ETC.