How do you get a starter bolt unstuck?
A penetrating oil or lubricant can be used to loosen the bolts if the socket wrench is too hard to turn. Spray the bolts with this oil and then allow 3 to 5 minutes for it to penetrate the grime.
What is the first step in starter removal?
How to Replace a Starter
- Safety First. Disconnect the battery.
- Remove the Wiring. Remove the wiring and positive battery cable from the starter solenoid.
- Remove the Starter and Bolts. Remove the starter retaining bolts.
- Compare to Verify.
- Transfer Heat Shield.
- Replace with New Starter.
- Secure and Tighten.
- Connect the Wiring.
How do you remove a starter from a Ford truck?
Once all bolts are out, you can remove the starter. Position the starter in place and then hand tighten the three bolts onto it first. Then torque the three bolts to 18 ft-lbs using your torque wrench. Re-install the two cables onto the starter.
What’s the best way to remove starter bolts?
Clamp the clamping portion of the vise grip over the head of the bolt so that it is snug and the rounded head will not be able to slide in either direction. Next, turn the vise grip counter-clockwise, removing and reapplying the vise grips as needed.
Where are the bolts on a car starter?
Finding the bolts is easy, yet getting to them may be a little more difficult. Usually the bolts are on the back side of the starter and, while they can often be seen from the front, can only be accessed from the rear. In order to reach them, one must first climb underneath the car.
Why does socket wrench not turn starter bolts?
Also, hitting the head of the bolts with a hammer or dull chisel can knock out some dirt or rust that may be preventing the bolt from turning. If the heads of the bolts have been rounded by either corrosion or from being stripped as a result of being taken out and reinstalled too many times, the socket wrench may not be able to turn them.