How many cubic inches is a 3208 Cat engine?
CAT 3208 Long Block Parts List:
| CAT 3126 Spec | Engine Data |
|---|---|
| Emissions | IMO Compliant |
| Bore | 114.3 mm (4.5 in) |
| Stroke | 127 mm (5.0 in) |
| Displacement | 10.4 L (636 cu in) |
Is the CAT 3208 a good motor?
3208 was always reliable there and it sipped fuel. I forget the rpms it ran at but it was turning pretty good. It put a load on it every time we started another electric motor, a 120kw, but it belched a little smoke lowered its tone and ran with it. I don’t think I ever turned a wrench on it.
What is a Caterpillar 3208 engine?
The 3208 is an eight-cylinder, four-stroke diesel engine with a V-8 configuration. It has a 114.3-millimeter bore and a 127-millimeter stroke. The engine displaces 10.4 liters. It has a cooling system capacity of between 47.3 and 56 liters and a lube oil system capacity of between 12 and 15 liters.
What kind of camshaft does a Cat 3208 have?
In its first iteration, the 3208 was a naturally aspirated engine with a flat tappet/lifter camshaft made of cast iron. Take a look at Figure 6and you’ll see this camshaft in the middle (letter B). The end of the camshaft has an inset photo to help you identify the lobe profile.
How much does a Caterpillar 3208 diesel engine cost?
Select a country to view available states. CAT 3208T Diesel Engine, 215HP, All Complete & Run Tested. $6,995.00 with Exchange For Information on this or any other engines. Please Call Cat 3208N Non-Turbo – Complete.
How tall is the fuel injector on a Cat 3208?
There have been three fuel injectors used on the 3208 engine (as shown in Figure 10). The one on the far left is referred to as the “S” injector because it was the injector used on the “40S” serial number series engines. You must use the hold down shown with this injector. It is .500˝ tall with a smooth OD of the spacer barrel.
How big is the fuel line nut on a Cat 3208?
fuel line nut as shown. When this injector is used in the lower horsepower naturally aspirated 3208 engine it will have an injector tip orifice diameter of .290 mm and when used in the higher horsepower turbo engine the injector tip orifice has a diameter of .315 mm.