How do I change an injector in a 2005 C-15 550?
Replace the clamp and spacer. Remove bolt (4), spacer (5), and clamp (6) . Place an identification mark on electronic unit injector (2) for installation purposes. Each electronic unit injector must be reinstalled in the original location in the cylinder head.
Why is my cat injector not working on my car?
The injectors have been fixed and the engine wouldn’t start. Two solenoids were changed, the nozzles & basically everything was serviced, cleaned. But the thing wouldnt start. No low pressure from the pump, its pumping fuel like it should, the fuel system has been very well bleed and the engine is still not starting.
How often do Cat injector seals go bad?
How many of you truck owners out there, with C15 / C16 / 3406E engines, have replaced the injector seals, only to have them go bad again within 50,000 miles? It is a real problem with those engines, especially with Cat re-manufactured heads. I have a permanent repair for the problem. Contact me with any questions.
What kind of engine is a 2005 C-15 ACERT?
We had one of our fleet trucks roll in this weekend with the coolant system filled with engine oil. The engine is 2005 model C-15 acert engine serial number MXS04506. My experience is with prior non e … read more
What should the Jake be on a C-15 ACERT?
The jakes are tricky, too. It helps to flash those engines to 550 HP/1850 torque when you run the overhead, if it hasn’t already been uprated. The stock factory injectors will handle this file
What kind of engine does a C-15 ACERT have?
The engine is 2005 model C-15 acert engine serial number MXS04506. My experience is with prior non e … read more what does it take to turn a C15 475 hp Caterpillar engine up to 550 hp?
What are the valve actuators on a C-15 ACERT?
Adjust the intakes to .015, the exhaust to .030 then adjust the 3 intake valve actuators to .020, and the 3 jakes to .027. The real trick is, when you adjust the actuators & jakes, is to snug it down against the feeler gauge & wait a minute for the oil trapped inside the piston to “seep” out.