What is the fault code on a Cummins ProStar?
Cummins does not list a 5018 – 13 code. They do have a 5018 – 11 and 5018 – 18 codes. Both of these are for failed regens due to improper temp increases across the DOC section of the aftertreatment system. This will turn on the CEL light. Basically during a regen the temps across the DOC should go from about 550 to 1000 degrees.
What is the C4 code on a Cummins truck?
C4 about 5 pounds. The 520906 code is from your body controller. At one point, trucks with two fuel tanks had an electric pump that would transfer fuel from one tank to the other as the engine only drew and returned fuel to one tank.
What are the fault codes for ISX Cummins?
They do have a 5018 – 11 and 5018 – 18 codes. Both of these are for failed regens due to improper temp increases across the DOC section of the aftertreatment system. This will turn on the CEL light. Basically during a regen the temps across the DOC should go from about 550 to 1000 degrees.
When did the ISX engine codes come out?
These codes pertain to the ISX engines built between 2007 and 2010. These engines are easily identified by having a DPF and regen on a regular basis. These codes do NOT pertain to engines using DEF. 111 Engine Control Module Critical Internal Failure – Bad Intelligent Device or Component
When did Cummins start issuing ISX fault codes?
These codes pertain to the ISX engines built between 2007 and 2010. These engines are easily identified by having a DPF and regen on a regular basis. These codes do NOT pertain to engines using DEF.
Which is the most severe ISX engine fault code?
415 Engine Oil Rifle Pressure – Data Valid But Below Normal Operating Range – Most Severe Level 418 Water in Fuel Indicator – Data Valid But Above Normal Operating Range – Least Severe Level 421 Engine Oil Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level