Do you torque the nut or the bolt head?
There is no simple answer to this as in some instances, it is perfectly acceptable to tighten the bolt head while holding the nut in place. In other situations, it’s acceptable to tighten the nut. It all depends on the application and the condition of the product or material being worked with.
Can I use a bolt without a nut?
Screws and bolts look somewhat similar, since both have threads. However, bolts can also be screwed into a threaded hole in order to fasten something down without the need for a nut, like a valve cover bolt that fastens down the valve cover to the rest of a car’s engine.
What is angle tightening of bolts?
With the torque- angle tightening method an initial tightening torque is specified, known as a snug torque (whose purpose is to pull – or ‘snug’ – the plates of the joint into metal to metal contact). An angle of turn is then specified for the bolt/nut to be rotated through.
What is the torque for bolts?
Different bolt sizes and grades have different torque specifications. For example, 6 mm bolts with a 10.9 grade have a maximum torque value of 10 foot-pounds, while the same-size bolts with a 12.9 grade have a maximum torque value of 12 foot-pounds. Consult your shop manual for the most precise listings.
What are torque specifications?
Torque specifications are for dry threads only. The fastener threads should be free of oil, dirt, grit, corrosion, etc. The hardware should turn freely without binding when tightened by hand. It is important NOT to lubricate hardware threads or seats. The friction at which torque is measured against should come from the hardware seats.
What is a torque screw?
Screw Conveyor Torque. Torque is defined as the twisting force exerted by the drive unit on the conveyor screw. Torque is transmitted through the drive shaft of the drive unit to the screw and converted to force to convey the bulk material.