Are TBI engines good?
tbi is about as reliable as one would expect a simple system with a few sensors and 2 injectors can be. i’ve never actually had a coolant temp sensor fail but i believe the ignition module has failed in my 350 tbi roadmonster.
How do you clean injectors on a traumatic brain injury?
Spray the injector or injectors with throttle body cleaner, and gently clean the exterior and the tip of the injector with the brush. Do not insert any metal objects into the tip of the injector, as this will enlarge the nozzle tip, permanently damaging the injector.
How do you adjust the idle on a TBI 305?
Unplug the IAC valve located on the passenger side, rear of the throttle body. Start the engine. Insert a T-30 size Torx driver into the Idle adjustment screw that is located behind the plug removed earlier. Turn the screw to adjust the idle speed to 650 RPM +/- 50 RPM.
How much HP can a 350 TBI handle?
The 350 TBIs only flow like 475 cfm, but can be bored to flow ~650 cfm. The bored TBI with the bigger injectors (96 lbs), the right chip, and a bumped up fuel pump (20 psi), should be able to support 345 hp (according to John’s calculations).
What is the difference between TBI and vortec?
The differences between them are that the TBI had the injectors right in front of the throttle plate, where the Vortec placed the injectors behind the throttle plate; and the TBI was a speed density system, whereas the Vortec used a mass airflow system to manage the fuel-injection system.
How to troubleshoot your TBI fuel injection system?
Troubleshooting your TBI Fuel Injection System Most of the problems encountered while installing your fuel injection system or after a time of operation are very simple. If your check engine light is on you more than likely have a hard fault meaning something is grounded out, unplugged, operating out of range or has gone bad. See
What kind of scan tool do I need for GM TBI?
A scan tool can be used and set up for a GM TBI application to read the data, or to check for stored codes. Consult a service manual or see below for any check engine light code definitions. You can use a late 80’s or early 90’s GM TBI definition. If you have access to a scan tool use a hook up for a 1990 350 cu. in. 5.7L Chevrolet truck.
What is the TBI code on a 1990 Chevy truck?
Consult a service manual or see below for any check engine light code definitions. You can use a late 80’s or early 90’s GM TBI definition. If you have access to a scan tool use a hook up for a 1990 350 cu. in. 5.7L Chevrolet truck. For some scan tools enter VIN 10th“L” 3rd“C” 8th“K”.
What are the specs for a TBI crate engine?
4. The cam in the TBI engine is just plain AWFUL. Specs on Stock TBI cam is .050″ tappet lift (intake/exhaust) is 165/175; and maximum lift with 1.5:1 rocker ratio (intake/exhaust) is .382/.402. I got those specs right off the Jegs website selling the new GM replacement TBI crate engines.