Is the DT466 diesel engine hard to kill?
The all-iron DT466’s wet sleeve technology revolutionized the medium duty engine market when it debuted and its overbuilt design means it’s exceptionally hard to kill. If you’ve ever been to a tractor pull and seen all of those 50-year-old IH machines running at the front of the pack, you’ve seen the DT466 platform in action.
What kind of fuel mileage does a dt466e get?
Btw: I have the 230 hp 660 tq engine and there seems to be plenty of power to run the 3.70 rear. I’ll have to hit the mfg. website and check how gradeability with the 3.70 compares to the 4.10, also I have to consider the cost, if the cost is higher than the possible fuel savings then I’ll just have to live with it.
What makes a 2003 International 4300 sputter and Miss?
I have a 2003 International 4300 with a DT466. I just had all the O-rings on the injectors replaced along with the wiring harness that goes to the injectors. Now once the truck gets up to running temp it starts to sputter/miss. Truck runs GREAT cold but once warm gets worse.
What makes a DT466 diesel truck go limp?
The engine is new, the injectors are all new, the MAP Sensor is new, the Baro Sensor is new, the Cam Sensor is new, the High Pressure Oil Pump is new, the fuel sensor and regulators are new, the computer is new. The truck will crank, and then go into a limp mode and blow tons of white smoke out of the stack. Any ideas would be appreciated.
Why does my 2004 DT466 engine not start?
I have a 2004 4300 international dt466 it cranks but no start. I have changed all sensors still nothing check fuel pressure injector orings im stuck. Engine position sensor shows up when u put computer on it. Where should I check for a broken wire maybe? Plug to sensor has power and sensor is good.
What kind of injection does the DT466 have?
Throughout its 45-year production run, the DT466 underwent plenty of changes, from mechanical injection to HEUI injection, non-intercooled to intercooled and emissions-free to emissions-friendly.
Where is the crank position sensor on a DT466?
If not replace the crank position sensor located on the bell housing on the driver s side . Pull the from fender off and you will see it . It is a two wire sensor with a square connector . Is it above the starter?