When did the Ford 460 come out?
1968
The 460 cubic inch eight-cylinder motor debuted all the way back in 1968 but found itself powering cars, trucks, and commercial equipment all the way to the end of the 1990s during its three decade run.
Does Ford still make a 460?
The Ford 7.5-liter, 460-cubic-inch V8 was part of the 385 engine family. When Ford’s full-sized cars were downsized in 1979, there was no longer a need for the 460 V8, but it continued as an option in the F-Series trucks and E-Series vans into the 1990s.
How much HP does a 460 make?
The Ford 460-cubic-inch, V8 engine has a cylinder bore of 4.36 inches and a crankshaft stroke of 3.85 inches. The output for 460 engines built before 1972 is 365 horsepower at 4,600 rpm and 485 pound-feet of torque at 2,800 rpm.
What Ford trucks have a 460?
The 460 made its first appearance in 1968 under the hood of the Lincoln Continental Mark III. While it was initially exclusive to the Continental Mark III, in 1972 made its way into Mercury vehicles and the Ford Thunderbird. The engine would stay a staple of the Thunderbird until 1976.
What is the best carburetor for a Ford 460?
List of Top-Rated Carburetors for Ford 460
| Model | CFM | Description |
|---|---|---|
| Holley 0-80452 | 600 | View on Amazon |
| Holley 0-80318-1 | 600 | View on Amazon |
| KIPA Carburetor | 600 | View on Amazon |
| Edelbrock 9913 | 750 | View on Amazon |
How many miles per gallon does a 460 get?
14.3 mpg on the highway, 10-12 in town, anywhere from 7-12mpg while towing depending on load.
How can I make my Ford 460 more fuel efficient?
Building an engine for torque will not in and of itself improve fuel economy. You’ll want to install either an overdrive transmission or extremely numerically low (under 3-to-1) rear-end gearing to keep the engine in its low-rpm sweet spot.
Where was the Ford 460 V8 engine made?
Beginning in 1968, the Ford 460 was manufactured at Ford’s plant in Lima, Ohio. A stock 460 cylinder bore was measured at 4.36 inches and had a 3.85 inch stroke with a rod length of 6.605 inches which would create a nice rod length to stroke ratio of 1.71:1.
How big is the engine block on a Ford 460?
After the mid-1980s, carburetors were replaced with electronic fuel injection with an output of 245 horsepower and 400 pound-feet of torque. A 460-cubic-inch engine block is 34 inches long, 32 inches wide and 30 inches high. The dry weight without gas and oil is approximately 720 pounds.
What are the upgrades on a Ford 460?
This mild grind was essentially 1 step above the typical RV cam for the 460. The cam was combined with new lifters (with plenty of break-in lube), new 926-16 valve springs and a rocker upgrade that included 1.73:1-ratio, aluminum roller rockers, new rocker studs and guide plates.
What was the firing order for the Ford 460?
Firing Order: 15426378 1973-1996 Ford 460 with 4 Barrel Carb Max Brake Horsepower: Both horsepower and torque for the 460 from 1973 until 1996 changed many times depending on emission controls, various fuel injection and carburetor setups as well as what the engine was used in.