What is the Cat test for injector solenoids?
Cat ET includes the following test that aids in troubleshooting injector solenoids: Injector Solenoid Test – The Injector Solenoid Test identifies an open circuit or a short circuit in the circuits for the injector solenoids. The test is performed while the engine is not running.
When does an injector solenoid have a problem?
Typically, problems with an injector solenoid occur when the engine is warmed up and/or when the engine is under vibration (heavy loads). Perform this procedure when the engine is at normal operating temperature. Pay careful attention to the condition of the wiring and the connectors as you perform this procedure.
How to set up injector of Caterpillar Model 3406E / C15?
Please show me how to setting up injector of CATERPILLAR model 3406E/C15 into cylinder head also adjusting valve clearance,jacob brake piston slave? HiCustomer Welcome back to JA, i am Buddy and i will try and help you out.
How to install an injector sleeve on a Caterpillar C15?
1. Install two NEW “O” ring seals on electronic unit injector sleeve. 2. Use retaining compound to contact surface of electronic unit injector sleeve on surface having Marked “X” in Figure 1. (4C-9507, 185-3988 or Loctite 620). 3. Use clean engine oil to lubricate “O” ring seals. 4.
What is the-6 code for Cat et?
Result: Cat ET displays a -6 code for each circuit that was jumpered. The harness between the ECM and the connector does not have an open circuit.Proceed to Test Step 4. Result: Cat ET does not display a -6 code for the cylinder with the jumper wire.
What are the diagnostic codes for an engine?
This procedure covers the following diagnostic trouble codes: These codes relate to the electrical circuit that includes injector terminals 1 and 3. These codes relate to the electrical circuit that includes injector terminals 2 and 4. These engines have Electronic Unit Injectors (EUI) that are electronically controlled.