What makes a 1999 dt466e engine shut down?
4. The only two sensors that will shut this engine down are the injection control pressure sensor and the cam sensor. To see if the ICP sensor is bad unplug it and run the engine. It will turn on the engine light but don’t worry about that. If it stays running replace the sensor.
Why does my DT466 start warm / hot?
The FACT that it starts good warm/hot MEANS that you DO NOT have a problem with the HPOP, IPR valve or other HEUI mechanical components because if you did, it would not start HOT very well. THEN re-install the good batteries and try it. On the cheap and quick, use a charger to boost voltage during cranking set to 12V Med or LESS.
What kind of car is the DT 466?
Can’t seem to figure this one out myself, so I figured I’d try here. 2003 International 4300 with the 466, and have been having some issues. Used to start and run beautiful, probably the best running dt I’ve driven.
What to do if your DT466 fires right off?
Try putting a battery charger on it, 12V low or Med at most, if it THEN fires right off, you’ve got a bad connection somewhere in the ECM or IPR circuits- This is VERY common. Thanks for all the input guys, I think I may have an idea what’s happening, correct me if I’m off track.
Can a 2005 International shut off while driving?
I have a 2005 International with a DT466. The issue I’m having is without warning, while driving down the road the truck will lose power and then shut off. No engine light comes on, no codes in the Dash changed the fuel filter checked the fuses in the battery box, Checked the relays underneath the hood and replaced the camshaft sensor.
How many times has DT466 truck broken down?
The guy at Southland International (where we have it had recently towed twice) said it that neither time were there any active codes, only inactive codes and “one triangle” which he said meant service work would soon be needed. So now it has broken down 4 times with the exact same symptoms.
What should fuel pressure be in 2005 DT466?
You will see the pressure relief ball. It may be partially unseated by debris causing a drop in fuel pressure. Anyway, you will notice a compuchek fitting on the top of the filter housing cap. You plug in a fuel pressure gauge here to test your fuel pressure. Need 20 psi to start, 65 psi is normal running pressure.
What makes a DT466 diesel truck go limp?
The engine is new, the injectors are all new, the MAP Sensor is new, the Baro Sensor is new, the Cam Sensor is new, the High Pressure Oil Pump is new, the fuel sensor and regulators are new, the computer is new. The truck will crank, and then go into a limp mode and blow tons of white smoke out of the stack. Any ideas would be appreciated.
Where to buy dt466e engine assemblies for sale?
Shop our massive inventory of rebuilt International DT466E Engine Assemblies at unbeatable prices. Enjoy our hassle-free online checkout or call to speak to an expert. Cooling Assembly. (Rad.,
What kind of engine does an Allison DT466 have?
DT466, Allison MT653, Spring Susp, Dual 50 Gallon Fuel Tanks, 2,500 Gallon Water System with New Pump and New Hose Reel 2021, 2 Rear and 1 Left Side Spray, High Back Air Driver Seat, Hand Throttle, AM-FM-Radio, U…
Where is the ICP sensor on the dt466e?
The ICP sensor is a three wire sensor located on the fuel/hp oil rail on the left side of the head. Its just about in the center of the rail just to the right of the hose from the hpop. Bad cam sensor or the positive wire (battery feed) on the key switch is burnt and loosing connection. Would be my first guess.