What to do if your Yale forklift has an error code?
Cause of Problem: B+ and / or B- missing at controller, defective battery charger, or defective battery charger What to do: Ensure the battery is connected, the key switch is on, and the brake override circuit is in the run position; also test your battery charger and motor controller and replace any nonworking parts
What should the idle speed be on a Yale forklift?
For GM 2.4L gasoline and LPG engines, the engine should idle at 775 to 825 rpm with no pedal and continuing to the governor speed which should be 2675 to 2725 rpm at full pedal.
What does shorted to ground mean on a Yale forklift?
A. 5 VOLT “A” SHORTED TO GROUND B. 5 VOLT “B” SHORTED TO GROUND C. 5 VOLT “C” SHORTED TO GROUND D. VSM FAILURE E. 5 VOLT ECU POWER SUPPLY SHORTED TO GROUND A. MECHANISM STICKY COMPONENT OPERATIONAL CHECK PROCEDURE OR ACTION: 1.
What are the problems with a forklift battery?
Below is a list of common problems associated with forklift batteries that occur over time. Listed are the different battery troubles, the conditions what come with them, what’s causing the problem, and how to collectively act upon it. Very low cell voltage and specific gravity during recharging and discharging Why is this happening?
What are the four parts of a Yale forklift?
These four parts are the design series, the manufacturing plant, the sequence of manufacture, and the year of manufacture of the lift truck. This system of numbering has been in place since 1995. (If these instructions look familiar, it is because Yale and Hyster forklift serial numbers are interpreted the same way.
Where can I find a forklift fault code?
On Yale and Hyster forklift fault code can be showed or can be in the system. In order to troubleshoot, diagnose, and also possible cases error codes, you can look for your error code and all useful description in the table below if you have any questions you can leave the question here Forklift Error codes and our technicians can help you
What causes a Yale and Hyster forklift to fail?
A. LOW SECONDARY FUEL PRESSURE DUE TO A FUEL RESTRICTION B. FAULTY ELECTRONIC PRESSURE REGULATOR (EPR) ELECTRICAL CONNECTIONS C. EPR FAILURE A. COIL DRIVER OUTPUT SHORTED TO GROUND B. WIRING/COIL OPEN CIRCUIT C. FUNCTIONAL FAILURE IN CONTROLLER