How do you bleed a hydraulic pump on a Ford 3000?
There is a bleed plug on the body of the pump itself, you should loosen that plug, but not remove it, and bleed it there first until you have fluid and no bubbles, then tighten that plug down and loosen the plug on the test port of the blocking plate and bleed it there until there are no bubbles. That should do it.
How do you check the hydraulic pressure on a 3000 Ford tractor?
Filler cap for the rear end is on top of the center housing, behind you right butt cheek as you are seated on your tractor. After checking fluid levels, get a 3000 psi pressure gauge and screw it into the test port on the hydraulic pump. Pump pressure should be about 2000-2500 psi. Post back and we will go from there.
Does a Ford 3000 tractor have a hydraulic filter?
Changing the hydraulic filter on your Ford 3000 Tractor can be challenging. However, once you get it done right, it won’t be a problem anymore the next time. First, pay attention to the suction and filter strainer. Make sure someone with experience is there to help you and will supervise as you work on your Ford 3000.
Does a Ford 2000 tractor have a hydraulic filter?
There are both a hydraulic filter and suction screen, but you have to pull the lift cover. The filter has a bypass valve if it gets plugged, so your 2000 has probably been bypassing fluid for 40+ years. The suction screen is deep down in the reservoir, you have to pull the lift cover and the PTO shaft to get to it.
Where is the hydraulic filter on a Ford 2000 tractor?
There is a hydraulic filter and suction screen deep down below your hydraulic lift cover (under the seat). If you want to change the filter, and clean the screen, you will have to pull the hydraulic lift cover.
How much horsepower does a 3000 Ford tractor have?
Ford 3000 Tractor has a 3-cylinder OHV, water-cooled engine, that produces 37 horsepower. It could be ordered with a Ford-built 158-cubic-inch gas and 175-cubic-inch diesel engine.
How to fix hydraulic problems on a Ford 3000?
To repair your problem the lift cover will need to be removed from the tractor. Either the control linkage is damaged or came apart or the valve is stuck inside. To make it work properly after repairing it you really need a couple of special setting tools from the manufacturer.
Which is the correct hydraulic pump for a Ford 3000?
The C5NN600A pump kit Yesterday’s Tractor sent you is the correct pump part number for a Ford 3000 tractor. Your hydraulic pump has been swapped out somewhere in its past, which is not uncommon. I would contact YT and explain your situation. They can probably cross-reference to find the correct kit for you.
Why are the lift arms going up on my Ford 3000?
The lift arms going up as soon as the tractor starts indicates the control linkage is damaged or the control valve spool is stuck. This is all under the lift cover. The added remote valve bolted to the top of the cover actually gets oil first and whatever is not used by it goes to the lift cover to work the arms.
Why is the hitch on my Ford 3000 not working?
3) Draft control or position control damaged. 4) Unload valve or back pressure valve faulty. 5) Lift piston seals damaged. 6) Unload valve plug worn. 7) Lift cylinder, lift cover, or pressure transfer tube cracked. Note that my manual is for a Ford 3600, so there may be some things that don’t apply to your 3000.