How to check a Cascadia with Detroit DD15 EPA10?
I have this cascadia with detroit dd15 epa10 having the code… you need to do a low re fen to check the sensors. I dont like either reading you posted. disconnect the def injector, start a low temp re gen, which you can do with the service link program and the readings on the sensors should be with 50ppm of each other.
Where can I buy a 2012 Detroit DD15 engine?
2012 Detroit DD15 used diesel engine for sale . 560 HP, tested and inspected with warranty. Call or visit our website for more info What’s Save Search and Email Alert?
How to clear a fault code on a Cascadia?
The fault code can be cleared using DiagnosticLink after the DEF dosing valve electrical connector is reconnected. To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic.
Do you need to replace the ATD on a Cascadia?
No, replace the ATD. For a One-box system, replace the DOC/SCR module. For a two-box system, replace the SCR module. Complete the ATD check list to identify cause of failure. Refer to section “ATD Checklist – EPA07/EPA10/GHG14” .
What kind of engine is in Detroit Cascadia?
The Integrated Detroit Powertrain is available in the Freightliner Cascadia and the Western Star® 5700. 2017 Greenhouse Gas-Compliant Engines: The flagship DD13 and DD15 engines are compliant 2017 Greenhouse Gas (GHG17) standards.
Can you replace the NoX sensor on a Cascadia?
Yes; Go to step 20. No; replace the outlet NOx sensor. Go to step 19. Run the EPA10 Perform Performance Check – Low Temperature ATD procedure to validate the NOx sensors are reading correctly. Refer to section “EPA10 Perform Performance Check – Low Temperature ATD” .
How does the fault code on a Cascadia work?
DescriptionThis Fault Code Sets When The Aftertreatment Control Module (ACM) Detects That The NOx Conversion Is Lower Than A Calibrated Threshold Monitored ParameterSelective Catalyst Reduction (SCR) Inlet NOx Sensor, SCR Outlet NOx Sensor
How to repair a Freightliner Cascadia Detriot DD15?
Check for multiple codes. If SPN 4353/FMI 5 is active confirmed along with SPN 3361/FMI 5, repair the open circuit between pin 3 of the ACM 120-pin connector and the DEF metering unit dosing valve connector for pin 2. If only SPN 3361/FMI 5 is present, Go to step 2. Disconnect the DEF dosing valve wiring harness connector.
What is the SCR sensor on a Cascadia?
Monitored ParameterSelective Catalyst Reduction (SCR) Inlet NOx sensor, SCR outlet NOx sensor