Why is my brake pressure light on?
If the brake warning light comes on when you apply the brakes, or is on continuously, it means that hydraulic pressure has been lost in one side of the brake system or that the fluid level in the master cylinder is dangerously low (due to a leak somewhere in the brake system).
How do you adjust a brake pressure switch?
How to Adjust a Brake Light Switch
- Locate the brake light switch. You’ll find it under the dashboard, near the top of the brake pedal.
- Push the button to adjust the on/off switch. Apply a good amount of pressure and the switch will either turn on or off.
- Determine if the button needs to be pushed in or out.
How do you test a brake pedal sensor?
Place the sensor on just one of the two wires and hold the brake pedal down as you do so. Then test the other wire. If power is connected and the switch is working properly, the test bulbs will illuminate. If it doesn’t light up, the brake light switch is faulty and will need to be replaced.
Are there any issues with my 2000 International 4700?
Discussion in ‘ Trucks ‘ started by Treetop, Oct 6, 2018 . Hello, i have a 2000 international 4700 with a dt466e. It was overhauled about 7,000 miles ago. Runs great until a few days ago. I thought water in fuel so i changed fuel filter and checked for water in tank. Changed oil today to look for anything out of the ordinary.
Why does the brake pressure light come on?
They must be timed to work at the same time.This will also cause the brake pressure light to come on.I used two test lights and ajusted switches so the lights came on at the same time.
What causes an oil leak in a 2000 dt466e?
Possible causes in order of likelihood: leak in the oil manifold, leak in the oil side of the injectors, blocked or faulty high pressure oil regulator, failing high pressure oil pump, starvation of high pressure pump. A good IH shop should be able to check the oil pressure while running. That should narrow it down. Click to expand…
Where is the oil pressure regulator on a dt466e?
The oil pressure regulator is located behind the oil cooler. I would pull it and see if the spring broke or the valve stuck open. Make sure when you re install the pump you prime it. Engine assembly lube white grease works well.