What causes a MaxxForce car to not start?
Verify with MaxxForce software or a mechanical gauge what your oil pressure is. Also I found a TSI on the International ISIS website for a hard start no start issue stating this could be caused by using NAPA filter 3994, FIL3994 or the wix and car quest versions. The problems with these filters are the are causing a low fuel pressure issue.
What makes an international MaxxForce DT No start?
Sounds different when cranking as well. Will not even start on starting fluid, not even a little bit. It does not build oil pressure while cranking. Codes are engine exhaust valve actuation system oil pressure, brake switch, and engine turbocharger 1 outlet pressure. SPN 4287, SPN 5541 and SPN 597.
What causes low fuel pressure on a MaxxForce 9?
The problems with these filters are the are causing a low fuel pressure issue. If you engine is a MaxxForce 9, the oil pressure regulator is on top of the oil filter housing. What codes do you have? What codes do you have?
Why does my MaxxForce DT have low power?
If the egr valve is sticking open slightly hard start will occur but the engine will also have low power. The air management test often finds this problem. Fuel pressure must be to spec for the year of engine you have. It can be measured at the test port on the intake manifold on epa 2007 through current design.
Are there any codes for the 2012 MaxxForce?
I … read more 2012 international workstar with maxxforce engine has no codes but 4 and 6 are missing with excessive smoke smells like raw fuel out exhaust. Cant tell much of difference when cut them two cylinders o … read more
Why is no start 2010 MaxxForce DT not working?
First, engine oil runs the high pressure side. Make sure you have oil in it. Then, for what ever reason it cannot build high pressure. Either there is a massive leak, pump failure, IPR failure or simple ICP sensor failure. Most common are the connector right at the IPR. There are updates for it.
Why does my MaxxForce DT start when cold?
Usually when the base engine oil pressure ( Lube oil pressure) is low it usually causes issues starting when cold .