What causes a torque converter to lock-up?
A cold engine temperature: There are cases where the converter may not lockup except the coolant temperature reaches 120°F. Lockout of the overdrive unit: An overdrive unit that is locked-up causes the torque converter lockup to also be locked out.
What is a torque converter lockup switch?
Torque converter lock-up is engaged through a solenoid mounted inside the transmission. This clutch acts just like a clutch disc in a manual transmission application. When the converter is “locked up” this clutch is forced against the front of the converter creating a direct drive from engine to transmission.
Where is the lock up solenoid on a TCC?
The Lockup solenoid is under the side cover. Sometimes the engine cradle needs to be lowered to get the side pan off. The solenoid is around $50. Dont go to a dealer, take it to a trans shop. $600 is WAY too much to pay for this.
What happens if you disconnect the TCC on a transmissin?
Transman says that if you disconnect the TCC you will cause the transmissin to overheat, due to the constant slipping of the converter. I have never bought that assunption and the gas mileage will not suffer much because the converter doesn’t lock up anyway until you reach cruising speed, and most cars would perform better if it didn’t.
Why do I need to lock up the torque converter?
The TCC System uses a solenoid-operated valve to couple the engine flywheel to the output shaft of the transmission through the torque converter. Lockup reduces slippage in the converter increasing fuel economy. For the converter clutch to apply, two conditions must be met: Internal transmission fluid pressure must be correct.
How can I Fix my Dodge diesel TCC lockup?
One very popular fix was to install a noise filter on the TPS signal wire back to the PCM, as the cause of the TCC cycling problem was a noisy or erratic TPS signal. This is generally common knowledge, and most have seen graphs and screenshots of the erratic TPS signal.