Why does my Mercury outboard stall when I put it in gear?
Outboard engine RPM’s are lower when they are in gear. They can die when put in gear because one or more cylinders may have a problem and are not firing. Once in gear the RPM’s are so low that the engine dies.
What does it mean when you put your car in drive and it dies?
Some common reasons for motor vehicle stalls include: An empty gas tank. A fuel mixture that isn’t rich enough (this is usually the cause of cold stalling and intermittent stalling) A faulty fuel pump, alternator or EGR valve.
Why is my outboard motor stalling?
Your outboard may be stalling for several reasons. Why does my outboard stall? Your outboard may be stalling & running out of fuel due to three issues. Either the lift pump has failed, the boat is out of fuel or there is an air leak or blockage somewhere in the fuel lines running fuel from the tank to the engine.
Why does my 2 stroke outboard stall?
If your two-stroke engine is stalling when you apply the throttle, likely causes include filters, gaskets, spark plugs, and vents. If all of these systems check out okay, you likely have an issue with the carburetor which will require cleaning or rebuilding.
Why does my boat start but not stay?
A spark plug fouled by fuel, carbon, dirt or oil on the electrodes may not produce a spark strong enough to ignite the air/fuel mixture and start your engine. A dirty flame arrestor/air box can cause your boat engine to stall. Make sure the air box is free from debris prior to each startup.
What to do if your Mercury outboard wont start?
Replace spark plug if necessary. Any Mercury 9.9 HP outboard engine that won’t start should begin working if you follow and apply the rules listed. Also, it’s highly recommended to download the factory repair manual anytime you plan to service your outboard. My 1995 10hp Mercury outboard won’t start. Where can I get directions to fix this motor?
Which is the best forum for Mercury outboard problems?
This is the best Mercury Outboard Forum on the internet, it’s yours! If you own a Mercury Outboard. Are you looking for good advice about your Mercury outboard engine problems and issues.
Why does my mercury 115 EFI not start?
My mercury 115 EFI four stroke develops an engine miss at around 5000 rpm. The rpm drops approx 200 to 400 rpm. This miss comes and goes. It appears … cold Engine cranks quickly but does not start. will start if using starting fluid. carbs rebuilt. new fuel,new squeeze ball, electric choke. new plugs …
Where did my Mercury outboard motor come from?
I bought this motor as a clearance in 2009 in Delaware USA ( new in crate) I then moved to Australia, and the motor stayed in the crate until 2 days ago…. … When I turn the key I get the beep, but there is a 2-3 hesitation before the motor starts to turn over. After a couple tries, the motor starts and runs …