How do I reset my 2013 Dodge Avenger?
2013-2014
- Without your foot on the brake pedal, press ENGINE START/STOP button to cycle vehicle to ON/RUN mode (make sure engine is OFF)
- Fully depress and release the accelerator pedal 3 times within 10 seconds.
- Turn the key to the OFF position and then back on to confirm reset was accepted.
How do you reset the computer on a Dodge Avenger?
How to Reset a Car Computer Open up the hood. Remove the positive terminal cable from the battery using your pliers or wrench. Go to your fuse box in your car , and look at the diagram. Keep the car disconnected like this for two to three minutes to clear the computer’s memory.
Why won’t my 2013 Dodge Avenger start?
Be sure you have a fully charged battery that passes a load test. Confirm that the engine immobilizer system (security system) is not activated thus preventing the car from starting. Basically, with a fully charged battery, and with the key held in the “start” position, the starter is either getting power or it isn’t.
How often should I change the oil in my 2013 Dodge Avenger?
Traditional motor oils should be changed after approximately 5,000 miles of service.
How do you reset the codes on a Dodge Avenger?
Gently press the gas pedal all the way down three times within a ten second interval. Turn the ignition to “Lock“….How do you reset a 2008 Dodge Avenger?
- Turn the ignition to the “RUN” position.
- Immediately press and release the accelerator pedal 3 times within 10 seconds.
- Turn the ignition off.
Where is the ECU fuse on a 2013 Dodge Avenger?
The fuses that run the interior of a 2013 Dodge Avenger are actually located in the engine compartment. This fuse box is called the integrated power module, and it contains many different fuses and relays. You can find it to the right of the engine, near the air filter assembly.
What causes a Dodge Avenger not to start?
Problem Description The anti-theft system may cause a no start condition due to electrostatic discharge (ESD) affecting the wireless control module (WCM). There is an updated WCM to correct this issue.
What do you do when your Dodge Avenger won’t start?
Dodge Avenger Won’t Start
- Put the key in the ignition of your Dodge Avenger and try to turn it.
- Check to see if the battery has a charge.
- Check the fuel level in your Avenger.
- Turn the key to the start position and listen for any noises that your Avenger makes.
- Open the hood.
Can a Dodge Avenger shift on second shift?
My 2009 dodge avenger will shift fine wnhen i started it up in the morning, but few minutes and it will get stuvk on first or second shift. The rpm also goes really high. My car starts the engine runs however it will not engage in gear. It was just running fine a couple of hours ago.
What kind of transmission does a Dodge Avenger have?
I own a 2009 Dodge Avenger , 2.4 L , 4 speed automatic. Shifts fine on cold start , gets stuck in 2nd after warm up. I changed the fluid & filter , no abnormal amounts of grunge in the pan , and same symptoms……
Why does my Dodge transmission not shift from 0?
Trying to cross a busy intersection from 0 doesn’t work!! Nearly got hit several times. 1-2shift&3-4 shifts are very late. engine is way too high in rpm range for these gear shift points, and when it does shift, alot of the time its soft and feels weak…
What makes a car not shift into the correct gear?
Car not shifting into correct gear,hesitates before shifting past ,2nd gear and also when shifting into reverse or drive car jerks into gears. I own a 2009 Dodge Avenger , 2.4 L , 4 speed automatic.