What does the code p0882 mean on a Dodge?
So there are a lot of Chrysler and Dodge vehicles that may set code P0882. So what is code P0882? It indicates low power input. The system tests for code P0882 when you turn the ignition from Off to Run, or from Start to Run.
What are the symptoms of a p0792 trouble code?
Symptoms of a P0792 trouble code may include: Numerous instrument panel lights illuminated What are some of the common causes of the code? Causes for this P0792 engine code may include: Defective or damaged Intermediate shaft speed sensor Electrical fault in the wires between the speed sensor and modules used
Why is my van still giving me p0734?
Still giving me P0734 and P0792 so I took it to a transmission shop for diagnosis and they found electrical noise interference induced on the Transfer shaft speed sensor wiring in the form of random spikes on his readout. he had the van running and stopped in neutral while he was checking his readout and he observed a spike on that sensor.
What does the code p0882 mean on a TCM?
It’s through operation of these output devices that the TCM controls transmission operation. Like any other electronic device, the TCM must have proper power and ground. Code P0882 indicates there isn’t enough power getting to the transmission module. This is usually due to a problem with the power input circuit.
How much does it cost to repair a p0876 Dodge?
The cost to diagnose the P0876 DODGE code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much does it cost to repair a p0888 Dodge transmission relay?
The cost of diagnosing the P0888 DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P0888 DODGE code detected?
What are the symptoms of a p0876 engine code?
Symptoms of a P0876 engine code may include: Vehicle starts off in 2nd or 3rd gear (limp in mode) Typically the causes for this code to set are: Open in the signal circuit to the TFPS sensor – possible Short to voltage in the signal circuit to the TFPS sensor – possible