Where is the thermostat located on a 1994 Ford Explorer?
My 94 was at the bottom left of the engine. The 93 has it at the top.
How do you change a thermostat on a 1994 Ford Explorer?
Coat the mating surfaces of the housing and engine with an adhesive type sealer. Position the new gasket on the thermostat and place the housing on the engine. Tighten the bolts to specification….
- Remove the 3 thermostat housing attaching bolts.
- Remove the thermostat housing.
- Pull the thermostat from the intake manifold.
How much is a thermostat for a Ford Explorer?
Ford Explorer Thermostat Replacement Cost Estimate. The average cost for a Ford Explorer thermostat replacement is between $287 and $313. Labor costs are estimated between $94 and $118 while parts are priced between $193 and $194.
How do I change thermostat housing?
How to Replace Your Vehicle’s Thermostat
- 2Place a bucket under where you’re going to be working.
- 3Remove the clamp.
- 4Pull off the hose.
- 5Remove the bolts that hold the thermostat housing in place and lift out the old thermostat.
- 7Drop in and secure the new thermostat.
- 8Replace the hose and hose clamp.
Where is the thermostat housing on a Ford Explorer?
Follow the upper radiator hose to the front driver’s side of the intake manifold, where it meets the engine. This is where the thermostat housing on your Ford Explorer is located. If necessary, remove the air cleaner duct for easy access to the housing. Loosen the clip on the end of the radiator hose and pull the hose off the thermostat housing.
How to test the thermostat in a Ford pick up?
In this article, I’ll show you how to test the thermostat in your Ford 4.6L or 5.4L pick up (van or SUV). As you might already be aware, a bad thermostat will cause one of two different conditions, either it will cause your Ford pick up (van or SUV) to overheat or cause the engine to never reach normal operating temperature.
What should I do if my Ford Explorer is hot?
Fill the radiator with reserve or new coolant. Start your Explorer and run with the heater blowing until the engine gets warm. Check for leaks. Do not attempt to drain the coolant from your Explorer if the engine is hot. Make sure the engine is cool before draining coolant.
How do you change the battery in a Ford Explorer?
Remove the negative battery cable from the battery if your Explorer has a 2.9-, 3.0-, 4.0- or 5.0-liter engine. This step is not necessary for 2.3- and 2.5-liter engines. Follow the upper radiator hose to the front driver’s side of the intake manifold, where it meets the engine.