How do you change the transmission fluid on a Acura TL?
- Step 1 – Warm up engine and remove splash guard. Start your Acura and let it warm up until you hear the radiator fan come on.
- Step 2 – Drain transmission fluid.
- Step 3 – Remove the airbox and hose.
- Step 4 – Remove the transmission filter.
- Step 5 – Replace the filter and assembly.
- Step 6 – Add new ATF fluid.
How many quarts of transmission fluid does a 99 Acura TL take?
7.6 quarts
1999 2000 2001 2002 2003 Acura TL Transmission Fluid Capacity
| Transmission | Fluid capacity | Fluid type |
|---|---|---|
| 5-speed M7WA automatic transmission | Total Fill 7.2 litres (7.6 quarts) | SL040 |
How do you check the transmission fluid on a 1999 Acura TL?
How Do You Check Transmission Fluid?
- Turn your Acura on. You’ll want your engine warmed up, so you can best check the levels.
- Locate the transmission fluid dipstick.
- Remove the dipstick and touch the fluid.
- Get a rag and wipe off the dipstick.
- Use a funnel to bring the level up to full.
What kind of transmission fluid does a 1999 Acura TL take?
Acura TL USA Built 1999, Dexron III (G)/Mercon V Automatic Transmission Fluid, 1 Liter by Febi®. Oil Type: Dexron III (G)/Mercon V. Volume: 1 Liter.
How many quarts of transmission fluid do I need for a Acura TL?
4.5 quarts with the filter change.
What kind of transmission fluid does a 2006 Acura TL take?
Dexron™ VI Automatic Transmission
Acura TL Automatic Transmission 2006, Professional™ Full Synthetic Dexron™ VI Automatic Transmission Fluid by ACDelco®.
Do you check transmission fluid hot or cold?
Turn on your car, leaving it in park, and let the engine run for a few minutes to warm up. Transmission fluid expands in heat and in order to receive accurate results, it must be under normal operating conditions. If the fluid is checked when the engine is cold, you may get false results indicating the fluid is low.
What kind of transmission fluid does a 1999 Acura 3.2 TL take?
Valvoline Synthetic Transmission Fluid Multi-Vehicle 1 Quart.
Is Acura and Honda transmission fluid the same?
Although each have their own part number, both fluids under the two part numbers above are the same. This means that you can use the Honda fluid in an Acura or the Acura fluid in a Honda car.
How to change automatic transmission fluid in an Acura TL?
Acura TL 2009-2014: How to Change Automatic Transmission Fluid Step 1 – Remove the plastic undertray. Warm up the motor/transmission with a 15-minute drive, and be sure to put the… Step 2 – Loosen the ATF fill cap. Before you drain the old fluid, it is a very good idea to make sure you can get
Where is the transmission dipstick on an Acura TL?
Then, with the engine off, check the transmission dipstick again, and top off the fluid to get its level line between the marks on the dipstick. The transmission dipstick is located under the hood, conveniently at the front of the engine compartment on the driver’s side.
Where is the drain plug on an Acura TL?
The drain plug is a 3/4-inch square recessed head. You can use a 3/4-inch drive ratchet without a socket attached, or a 1/2-inch or 3/8-inch to 3/4-inch socket adapter to remove it. The drain plug is found underneath the transmission on the passenger side. This plug can be hard to remove, so you may need to use a breaker bar to gain more leverage.
How often should I change my transmission fluid?
Transmission fluid dipstick full marks. Often referred to as a “3 x 3” flush, this means at least three quarts of ATF changed three times within a short period of time. Many experts believe this is unnecessary if regular drain and fills are done every 30,000 miles come rain or shine.