Is it hard to install brake rotors?
Modern brake systems are complex, and while replacing your brake pads and rotors is a fairly straightforward process, it could go wrong if you aren’t sure what you’re doing.
Do you need to torque caliper bolts?
7. Over torquing the caliper guide pin bolts: Caliper guide pin bolts typically need a 13mm wrench to remove. It is a rookie mistake to go nuts on these bolts and break the heads off. Typically these bolts require only 25- to 35-ft/lbs of torque.
What is the service manual for a Toyota Sienna?
SERVICE DATA TORQUE SPECIFICATIONS PROPELLER SHAFT SERVICE DATA TORQUE SPECIFICATIONS DRIVE SHAFT SERVICE DATA TORQUE SPECIFICATIONS DIFFERENTIAL SERVICE DATA … If any washer does not work or the warning message appears on the multi-information display, the washer tank may be empty.
What should I know about my Toyota Sienna?
1. INSPECT FRONT AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION) Perform a diagnostic system check. 2. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED) Perform a diagnostic system check. When the front bumper of the vehicle o Short in Front Passenger Side Squib 2nd Step Circuit
What kind of torque does a Toyota Celica have?
TORQUE SPECIFICATIONS TOYOTA APPLICATION FT-LBS (N-m) AXLE SPINDLE NUT CAMRY (1994-92) 217 (294) CELICA (1992) & SUPRA 203 (276) CELICA (1994-93) 166 (226) CRESSIDA (REAR 1993-92) 203 (276) CELICA ALL-TRAC (REAR 1993-92) 166 (226) PREVIA & TERCEL 166 (226) MR2 (1994-91) NON-TURBO 152 (206)
How to remove a sensor from a Toyota Sienna?
REMOVE NO. 1ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System) (See page PM-19) 2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System) (See page PM-19) 3. REMOVE REAR BUMPER ENERGY ABSORBER 4. REMOVE REAR BUMPER BAR PLATE Remove the 4 clips and the rear bumper bar plate.