What kind of oil goes in a Land Cruiser?
The Toyota Land Cruiser uses SAE 5w-30 viscosity, fully synthetic motor oil in its engine. The vehicle has an oil capacity of 5.5 US quarts.
How many quarts of oil does a 97 Land Cruiser take?
7.6 quarts
Capacity: 7.6 quarts (with filter)After refill check oil level.
What oil should I use in a 1997 Toyota Corolla?
Engine Oil
| Viscosity: | 10W-30 (Above -18) 5W-30 (Below 38) SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 3.9 quarts (with filter)After refill check oil level. |
| Torque: | 25 ft/lbs (Oil Drain Plug) |
How much oil does an 80 series LandCruiser take?
Model: Toyota Land Cruiser 80, J8 (1989 – 1998)
| Engine | Capacity/Filter capacity litres(liters) | |
|---|---|---|
| Land Cruiser 80 4.5 24V (1992 – 1998) | 1FZ-F, 1FZ-FE | 7.4 / 0.5 |
| Land Cruiser 80 4.2 D (1989 – 1998) | 1HZ | 9.3 / 1.3 |
| Land Cruiser 80 4.2 TD (1989 – 1998) | 1HD-T | 9.3 / 1.3 |
How much oil does a Toyota Landcruiser have?
Toyota Landcruiser engine oil capacity Engine Capacity/Filter capacity litres (liters) Land Cruiser 70 2.5 TD (1985 – 1996) 2L-T 5.8 / 1 Land Cruiser 70 3.0 TD (1992 – 1996) 1KZ-T 8 / 0.7 Land Cruiser 70 3.5 D (1990 – 1993) 1PZ 9 / 1.3 Land Cruiser 70 4.2 D (1990 – 1996) 1HZ 9.5 / 1.3
What kind of Grease do you use on a Toyota base?
Your Toyota Owner’s Manual or Factory Service Manual specifies the proper type of grease to use on each part – either a moly or lithium base. Some feel it’s not necessary to use both types of grease (due to having to keep 2 grease guns available), but I’m a strong believer in following the factory recommendations.
Do You Grease the stops at an oil change?
It’s a good idea to grease the stops at every oil change, and don’t forget — there are four total to grease! The balljoints retain grease with a rubber boot around the joint itself. When greasing your ball joints, lightly poke the boot with your finger to determine how much grease it needs.
How can I get grease out of my Toyota boot?
When greasing your ball joints, lightly poke the boot with your finger to determine how much grease it needs. If the boot is taut, the joint doesn’t need any. But if you can easily push it in, give the joint a couple of pumps from the grease gun.