How do you program a 2008 remote?
2008 Chevrolet Silverado Keyless Entry Remote Programming Instructions
- Insert Key and turn to ON position so you can access Driver Information Center.
- Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays.
- Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays.
How do I program a new key for my 2008 Silverado?
1. Insert a new cut key in ignition and turn key to the ON position for 10 minutes and 30 seconds. 2. Within 45 seconds turn the key to OFF and then back to the ON position for 10 minutes and 30 seconds.
How do you program a key for a 2008 Chevy Silverado?
How can I reprogram my Remote key fob?
Make sure that the ignition is not in the radio mode, and do not start the engine. Press the lock button on the remote key With the key in the ‘On’ position, press the fob’s lock button and turn the key back to the ‘Off’ position. Repeat this process at least three times, ending the cycle with the key in the ‘On’ position.
When do I press the lock button on my Remote?
This indicates that you have entered the programming mode. Once this is done, press the lock button again within five seconds, and the programming will succeed. If there are additional remotes, press the ‘Lock’ button within 10 seconds after you enter the programming mode to program those remotes as well successfully.
Why is my remote keyless entry not working?
Note: If your vehicle cannot enter programming mode, then you cannot program any remote. This indicates either no keyless entry installed on the vehicle or a defective keyless entry receiver module. If you have any difficulties with programming your vehicles, contact us at [email protected].
How do you program a push fob remote?
PRESS the DISP button to ENTER Programming Mode. WHEN the message “PUSH FOB” is displayed, PRESS and HOLD the LOCK and UNLOCK buttons at the same time on the first remote to be programmed for 15 seconds. The vehicle will sound to indicate successful programming of the remote.