How tight should transmission pan bolts be?
It should seal back up fine– 10 to 12 foot-pounds, like cdowns said. A 1/4″ ratchet, hand tight, is about right.
Do you need a torque wrench for transmission pan?
Proper transmission service requires us to remove the pan on those transmissions that have them. We should always tighten transmission pan bolts to the specified torque, when we install them. This is done with a torque wrench. If we use this method, the torque on the bolts are correct.
Does a deep transmission pan help?
As you know, automatic transmissions need a transmission pan in order to hold all of the ATF (automatic transmission fluid). Some can actually help to improve the transmission’s performance. For example, deep pans can help tremendously with cooling since your transmission is able to contain more ATF.
How many bolts are in a transmission pan?
16 or 17 bolts for Trans.
What are the torque specs on a Toyota Camry?
2000 Toyota Camry 2.2L. Planning to drop the transmission pan this weekend, but manual says torque specs is only 43inlbs. It seems low. I would expect between 80-100 inlbs. What is the proper torque specs for the rubber gasket? Thanks, 2000 Toyota Camry 2.2L.
Do you need a pan for a manual transmission Camry?
A manual transmission does not have a pan but the drain and fill plugs have the same torque as the drain plug on the automatic. As a general rule, a four-cylinder engine requires more torque than a V-6.
How big are the bolts on a Toyota Camry?
The oil pan under the car is mounted with bolts tightened to around 80 inch-pounds. The pan that contains the automatic transmission fluid is mounted with its bolts tightened to approximately 69 inch-pounds; the drain plug is tightened to 35 to 36 foot-pounds.
What are the torque specs for the transmission pan?
Planning to drop the transmission pan this weekend, but manual says torque specs is only 43inlbs. It seems low. I would expect between 80-100 inlbs. What is the proper torque specs for the rubber gasket? Thanks, 2000 Toyota Camry 2.2L. Planning to drop the transmission pan this weekend, but manual says torque specs is only 43inlbs.