What should I know about the 100 series Landcruiser?
TECHNICAL A forum for 100 Series Landcruiser owners to exchange technical information. This represents the combined *opinion* of the group and should be used as a guide only, as to what is known/possible with 100 Series, as adjustments, technical tips, and accessories.
How do you replace the ignition barrel on a Land Cruiser?
It’s actually very easy – if you have the key & it will turn to the accessory position. There is a small ‘button’ on the top of the barrel you can get to by removing the trim just below the speedo clocks -press it in with a small screwdriver when the key is vertical -you can feel it go down – and it just pulls out!
When did the Toyota Land Cruiser come out?
In this article, we consider the fourth-generation Toyota Land Cruiser (100/J100), produced from 1998 to 2007.
Where do you find the part numbers on a Land Cruiser?
Click on the BLUE HIGHLIGHTED NUMBERS in the line drawings to display a COMPLETE part listing of that part number.
How do you Bleed the brakes on 100 series cruiser?
You must start bleeding the brakes at the wheel farthest from the master cylinder (usually the right rear), then the next farthest from the master cylinder, then the next, then the closest. If your master cylinder is at the left front of the car, start with the right rear, then the left rear, then the right front, then the left front.
What should I know about clutch Tech on a landcruiser?
On Clutch Tech, Stewart takes you through the Gearbox Cleaning and Lubrication Procedure on a VDJ76 LandCruiser. It is vital to ensure that the clutch components are suitably lubricated to avoid premature wear as well as keeping the clutch actuation smooth. Loading…
Is the air con clutch the same on a diesel Land Cruiser?
This is on a petrol model, the diesel will be different although the way the clutch fits together is the same they just have different pulleys and they’re in different places. With the front under tray removed (can’t really call it a bash plate can you!) access to the compressor pulley and drive belt tensioner is not too bad.