Can you replace a driveshaft at home?
Changing your driveshafts is actually a simple task that a home mechanic can undertake without too much trepidation. It’s just a case of being thorough, being safe, and of course, having your trusty Haynes Manual to hand.
How do you remove a rear differential drive shaft?
Using a plastic hammer gently shock the driveshaft loose from the differential flange by striking the rear yoke (U joint mount). At this point the back half of the shaft will be free so hang onto it. On some cars there will be a center support which must be undone by removing the two center support mounting bolts.
Is it difficult to replace a driveshaft?
Now you will have to remove the bearing cups from the new joint and then start one into the driveshaft. You will have to do this gradually as you try to complete the process. In the end, the Drive Shaft Repair process might feel challenging, but you can complete it with great results.
Is a driveshaft expensive to replace?
Replacing a drive shaft on a vehicle can cost hundreds of pounds. It’s a common vehicle repair that motorists can avoid by carrying out a simple Do-It-yourself check that takes a couple of minutes. Rubber gaiters are located at each end of these shafts.
How long does it take to change a driveshaft?
even a novice should have it done in about 2-3 hours taking your time and following the manual.
How to remove and replace a rear drive shaft?
ABS ring removed ready for transfer to the new drive Here is the end of the driveshaft in the swingarm Remove drive shaft by gently pulling it out Grease splines on BOTH ends of shaft Grease splines on input shaft of rear drive Reinsert drive shaft with U joint forward Pushing drive shaft into place
How much does it cost to replace a driveshaft in a car?
If you were to take you car into the have the driveshaft removed as a standalone labor repair it would cost between $55.00 and $75.00 (US). Driveshaft replacement costs will run between $250.00 and $350.00 (US) and are usually a dealer item.
Can a stock drive shaft be replaced on a 2012 Wrangler?
On newer 2012 Wrangles, the stock drive shaft will come in contact with the exhaust cross pipe after the Jeep is lifted. An exhaust spacer can be used to provide enough clearance, but a new thinner drive shaft is often a better solution.
What should I do before re-installing a driveshaft?
Before re-installing the driveshaft apply a small amount of grease to the yoke. This will help lubricate the output shaft seal in the transmission or transfer case. There is a dust boot along with the rear seal which is incorporated within the transmission or transfer case tail housing seal.