How do you reset the airbag light on a toyota Sienna?
Resetting the SRS Light To do this, turn the key in the ignition, but do not start the car. Just turn it far enough to turn on the electrical. As soon as the SRS indicator light turns off, then turn the key to the off position and then turn it on again. Repeat this procedure about 5-7 times.
How do you reset the airbag light on a toyota Prius?
How to Reset the Airbag Light on a Toyota
- Find the fuse panel cover under the steering column and open it with your fingers. Pull down on it from the top.
- Look for a yellow electrical connector.
- Take a paperclip and unfold it.
- Put the yellow electrical connector back in place and close the panel cover.
How do you reset the airbag light on a 2006 toyota rav4?
Insert a paper clip or short piece of wire between 4 and 13. The light should go off in about 3 seconds. Then turn the ignition key off, remove the paper clip, and turn the key back on and the light should be out.
How do you reset the airbag light on a Lexus?
Procedure
- Connect your OBD-II diagnostic tool to the diagnostic port located under the dashboard, driver’s side.
- Turn on ignition to position II.
- Allow the OBDII tool to communicate with your car’s internal computer (protocol sorting).
- Depending on the scanner, you may have to manually select make and model.
What does it mean when your airbag light is blinking?
There are several reasons. It could mean that your battery backup is drained, that you have a worn-out airbag clock spring, or that your SRS airbag control module is faulty. It can also mean that something is wrong with your seat belts or impact sensors.
Do you clear trouble codes before resetting airbag light?
Do never clear the trouble codes before you fix the problem caused by the airbag light. Read the codes and get information about what can cause the problem and therefore continue the diagnosis. You should never just reset the airbag light without repairing the problem.
Where can I find the air bag light code?
You can read the number of flashes and it will give you a code (codes listed below for ford ranger and Mazda B3000). If your code is not listed, just google the year, make and model of your car along with “airbag light code” (ex. 2001 Mazda B3000 airbag light code).
What does the code on the air bag indicator mean?
If the system detects any problems, it gives you a signal through the airbag indicator by flashing the light several times, giving you the specific problem the test has detected. These flashes are codes, each having its own meaning. The supplemental restraint system (SRS) warning light is most commonly known as the airbag system light.